Hallis Hudson Corded Wood Pole Fitting Instructions

Corded Wood Pole
Fitting Instructions
Tools you will need...
Spirit Level
CORDED WOOD POLE APPROXIMATE WEIGHT LIMITS
Bracket Type
Clasp, Metal and Wood Architrave
Recess Bracket
fit your corded wood pole...
5mm
5mm
45mm Diameter
Fig.4
5mm
Tape Measure
45mm Pole Diameter
Up to 2.7kg per metre
Up to 3.5kg per metre
METAL BRACKETS
5mm 25mm
WOOD CLASP BRACKETS
WOOD ARCHITRAVE BRACKETS
50mm
Fig.7
Screwdriver Pencil
55mm Pole Diameter
Up to 4kg per metre
Up to 5kg per metre
Fig.1 Fig.2
5mm
55mm Diameter
Fig.3
Fig.5
Fig.6
Fig.8 Fig.9
Allen Key
Step 1: Mark your Screw Positions – these
vary by bracket type as follows:
Metal Brackets
Fit the brackets 5mm from each end of the
pole, this will be 25mm from the track (fig 1),
then screw the bracket button clockwise to
tighten (Fig 2).
With brackets attached, hold the pole to the
wall and, ensuring that the pole is level, mark
the screw positions (Fig.2).
Wood Clasp Brackets
(poles up to 210cm only)
Slide the brackets on to the pole and put them
5mm from each end of the pole (Fig.3).
Screw into the hole on the clasp bracket to
secure to the pole (Fig.4).
With the brackets attached, hold the pole in
your required position, ensuring the pole is level
and then draw around each of the bracket
bases.
Using the allen key provided unscrew the
backplate from the bracket (Fig.5).
Position the back plate in the centre of the
drawn circle ensuring the hole on the stem of
the backplate is facing upwards and mark the
screw positions (Fig.6).
Wood Architrave Brackets
(poles up to 210cm only)
FIt the brackets 5mm from each end of the
pole and this will be 50mm from the track
(Fig.7).
Screw into the hole in the bracket cup to secure
to the pole (Fig.8).
With brackets attached, hold the pole to the
wall and, ensuring that the pole is level, mark
the screw positions (Fig.9).
Drill