QTP 10901 Quick Start Manual

PART # 10901
Wireless QTEC Controller
Thank you for your purchase of the Wireless QTEC Controller. This controller will support both single
and dual Quick Time Electric Cutout applications. Your kit comes with the wireless receiver and 2 key
fob style remote controllers.
Install Instructions:
1. Find a suitable, secure, dry location for installation of the wireless control box. Receiver must be mounted
inside the vehicle and to a wired fused ignition power source or warranty will be voided. Remember you will
need to supply both a 12volt ignition power source as well as a ground.
BE SURE to run the Positive (Red/+) wire to your vehicle's 12v hot source and the Ground (Black/-) wire to a
suitable ground on the chassis. Please note:
receiver!
2. After securing the receiver and connecting power and ground, hook up your intermediate wires between
the valves and receiver box. Be sure to route the intermediate wires so they don't come into contact with your
exhaust system or any other area of the vehicle that could cause scraping & chaffing.
You're Done!
ANTENNA
Red Receiver Box
wireless receiver box
Hooking these wires up backwards will damage the
OPEN
Operation Instructions
1. To open the cutouts, hold the "OPEN" button
until the desired exhaust sound is achieved. It
will take approx. 5-6 seconds to open the valve
to the full open position.
2. To close the cutouts, hold the "CLOSE" button
until the desired exhaust sound is achieved.
TIP: For best results, lubricate the cutout valve
butterflies at least once a month to keep them
free of debris and carbon build up.
intermediate wire
(+) 12v Power Source
(-) 12v Ground
TECHNICAL SUPPORT
(864) 913-1999
Monday through Friday
9AM-4PM EST
email
sales@quicktimeperformance.com
CLOSE
Red Remote
LEGEND
12v Power Input
12v Ground Input
Antenna Wire