YOW! CraftY Cutter Quick Start Manual

3. Blade installing instruction
3)The tip length can be adjusted by turning the gold knob
counterclockwise
4)Adjust the length of
5)Turn the gold knob clockwise to fix the tip length
the tip of the tool holder
by turning the silver knob
1) Press the silver
button to eject the blade
4. Blade tip and blade force / speed value recommended settings
The blade tip recommends leaking a length of about 0.2 mm,
but new users tend to use too longer blade tip.
Our idea is to cut only the surface of the sticker,
but leaving only the minimum scratches under the bottom.
This way you can easily tear off the adhesive. If you can't cut
through a small corner or some small details, you can
increase the length of the blade.
The recommended speed setting is 600 mm / s
The blade force setting 10 - 20.
5. Place material
Step 1. Pull down the pinch wheels
assembly lever.
Step 2. Move the pinch wheel assembly again the steel axis.
Step 3. Load the material, at least 2 pcs pinch wheels pressing the material.
Step 4. Pull up the pinch wheels assembly lever, make sure material holding well.
Step 5. The blade is the origin point for cutting, move the blade carriage to specify
position and then start cutting.
Step 6. If it is print and cut job, need to move the blade tip around 3mm close to the
first mark.
2) The blade can be inserted
here, be careful that the tip
of the blade can easily hurt you.
Set the blade tip to
only the surface of
the material without
cutting the bottom layer
The most commonly used 45-degree case (red cap)
Thin material uses a 60-degree knee (blue cap)
First Mark
Quick Start Guide
1. Verify the Package Contents
45 degree blade 2pcs
Blade holder 1 pcs
60 degree blade 1 pcs
Power adaptor 1 set
2. Note the Names of Parts
Blade holder seat:
Tightener for Locking
Blade Holder
Blade carriage
(Built-in Camera)
USB Power
U-disk
cable port
cable
interface
port
USB Cable 1 pcs
Cutting Mat 1 pcs
Pen tool 1 pcs
Pinch wheels assembly lever：
Up for pressing material, down
for release material
Power button:
Click for power on,
Hold on 3 seconds for power off.
Pinch wheels assembly
Touch screen
pressure lever：
control panel
Up for higher force pressing,
down for normal force.