Advertisement
Advertisement
Table of Contents
Summary of Contents for Inter-m DIV-9123
-
Page 1: Electronic Crossover
DIV-9123 Electronic Crossover Copyright 2004 Inter-M Corporation... -
Page 2: Table Of Contents
Welcome ... 3 Unpacking ... 3 Warnings ... 3 Operation... 5 Electronic Crossover ... 6 Features ... 6 Front Panel Controls... 7 Rear Panel Controls ... 8 Connections... 9 Schematic ... 10 Specifications... 11 Contents... -
Page 3: Welcome
Welcome A personal welcome to you from the management and employees of Inter-M Thank you for purchasing this fine Inter-M product. All of us here at Inter-M are dedicated to providing you the highest quality products and the best value. - Page 4 DIV-9123 Electronic Crossover 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other devices (including amplifiers) that produce heat. 9. Do not defeat the safety purpose of the polarized or grounding type plug. A polarized plug has two blades, with one wider than the other.
-
Page 5: Operation
DIV-9123 Electronic Crossover Operation Make certain speakers and input sources are properly connected before switching the unit on. Keep volume levels at minimum gain before switching on. NOTE: The system’s operation is delayed by approximately three seconds after pressing the AC Mains power switch. This is due to the built-in protection circuitry, designed to... -
Page 6: Electronic Crossover
DIV-9123 Electronic Crossover Features Two-way Stereo or Three-way Mono Operation • Functions in either mode with extra mono subwoofer channel. • Two-way stereo mode: low, high. • Three-way mono mode: low, mid, high. XLR Inputs and Outputs • Balanced, line-level, professional connections. -
Page 7: Front Panel Controls
Front Panel Controls 1. Input Level Controls Clockwise rotation yields an increase in level. 2. Peak LED When the maximum output level exceeds +4dBu (at 0db=0.775 V rms) this peak LED illuminates. User Tip: Decrease input level until LED stops illuminating. 3. -
Page 8: Rear Panel Controls
Rear Panel Controls 1. AC Connector Connect the supplied standard AC input cable here. 2. AC Fuse Holder This holder contains the AC overload protection fuse. If the fuse has blown out, replace it with a fuse of the same type and rating. If the fuse continues to blow, refer servicing to a qualified service technician. -
Page 9: Connections
DIV-9123 Electronic Crossover Connections... -
Page 10: Schematic
DIV-9123 Electronic Crossover Schematic... -
Page 11: Specifications
Specifications ELECTRICAL Crossover Mode Crossover Frequency Crossover Cutoff Slope Subwoofer Frequency High Pass Filter Input Level/Connector Input Impedance Maximum Input Output Level/Connector Output Load Impedance Maximum Output Frequency Response Distortion (THD) Signal-to-Noise Ratio GENERAL Power Source Power Consumption Power Switch Weight Dimensions Specifications and design subject to change without notice for improvements. - Page 12 Korea and China, and sales and marketing operations located in Japan, Europe, and the U.S.A. With more than 850 employees around the globe, Inter-M is well-poised for further growth and expansion.