Summary of Contents for VALD FDMax
- Page 1 ForceDecks Instruction Manual for FDMax, FDLite (v.2), and FDMIni Version 1.0 2022...
-
Page 2: Table Of Contents
Turn On and Off..........................8 Getting Started: ForceDecks Software ................ 9 Setup Your Software ........................10 Minimum Device Requirements ....................10 Bluetooth Connection ........................ 11 Using ForceDecks ..................... 11 Safety, Care and Maintenance .................. 11 VALD ForceDecks Instruction Manual v.1.2022... -
Page 3: Important Notice
This equipment complies with FCC‘s RF radiation exposure limits set forth for an uncontrolled environment. End user must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. VALD ForceDecks Instruction Manual v.1.2022... -
Page 4: Introduction
Introduction This document provides information about the installation and use of the FDMax, FDLIte (v.2), and FDMini ForceDecks systems, including the assembly of hardware and installation of software. Welcome to ForceDecks ForceDecks are a dual force plate and auto-analysis system, used to analyse an individual’s balance, strength and movement strategies in a range of exercises and jumps. -
Page 5: Getting Started: Forcedecks Hardware
This force causes a change in voltage within the sensors, that ForceDecks then calibrates to measure how much force has been applied. This enables ForceDecks to collect total force data over time. ForceDecks Components The ForceDecks FDMax, FDLite (V.2) and FDMini systems consists of the following hardware: VALD ForceDecks Instruction Manual v.1.2022... -
Page 6: Forcedecks Setup
Note: If clients are unsure about the rigidity of their floor, they can check for vibrations by examining a force-time trace or by sending a recording to support@vald.com for assessment. We also recommend using a spirit level to identify an even part of the floor and marking out the space if clients are planning to move the plates. -
Page 7: Battery
FDMini 20+ hours Approximate charge time (from empty charge) FDLite, FDMax, FDMini 24 hours If it recommended to connect ForceDecks plates to a power source for at least one full day every month, as the batteries will slowly discharge over time when not in use. -
Page 8: Charging Forcedecks
Do not charge a device if your Mini-USB cable or wall adapter are damaged. • While other brands of wall adapter may successfully charge your device, we recommend only using VALD supplied adapters. • Your ForceDecks will automatically turn off after a period of inactivity. -
Page 9: Getting Started: Forcedecks Software
ForceDecks Windows application • ForceDecks iOS application • ForceDecks Jump • ForceDecks LeaderBoard, and • VALD Hub. *Users must activate their ForceDecks software within 7 days of installing the software onto their device, and annually thereafter. VALD ForceDecks Instruction Manual v.1.2022... -
Page 10: Setup Your Software
Setup Your Software To setup your software, scan the QR code or Or visit our website to access the ForceDecks Starter’s Guide: https://support.vald.com/hc/en-au/articles/4999028480025 Minimum Device Requirements The following specifications are recommended for any device running ForceDecks Windows software: Windows Operating System... -
Page 11: Bluetooth Connection
Bluetooth Connection ForceDecks plates (FDMini, LDLite (V2), FDMax) can be connected to a laptop via Bluetooth. Note: To enable Bluetooth connectivity the latest ForceDecks Firmware must be installed, and only one set of ForceDecks plates turned on. To connect ForceDecks plates to a laptop or iOS device via Bluetooth: 0.