Summary of Contents for JINJUNYE Aquajack 600
- Page 1 Robotic pool cleaner for aboveground pools Instruction manual Motor voltage: 7.4V DC Battery: 7.4V /4000mAh Waterproof grade: IPX8 Charging power: 8.4V DC, 1.5A Give time to home, Give home to JINJUNYE...
-
Page 2: Safety Warning
SAFETY WARNING When installing and using this electrical equipment, you should always follow the basic safety precautions. Please read the following carefully Warning! The cleaner is not a toy, and is operated by people older than 8 years age. Any people who operates the cleaner, has to read the manual carefully before work it. -
Page 3: Battery Disposal
(5)Do not handle the cleaner and charger with wet hands and bare feet， when charging the cleaner. (6)Disconnect the charger from power when not in use. (7)If the wire is damaged, it must be replaced by a new charger to avoid danger. -
Page 4: Assembly And Operation
Assembly A: Floater B: Upper cover B-1: Jet head C: Filter D: Bottom base E: Charger There is a rotation jet head at the upper cover, the water is passing from bottom to the jet head to make the robot moving. - Page 5 Power on Turn on the switch, loosen the rope on the float, Adjust the length of the rope to ensure that put the robot horizontally into the pool, and wait the length of the rope is at the same height as for the robot to sink freely to the bottom.
-
Page 6: Maintenance And Storage
Maintenance and storage 1. The battery discharges itself during storage. Make sure the robot is fully charged before storage. 2. When not in use, you must recharge the battery at least every three months. •Unplug the external adapter from the socket and then the charging cable from the external adapter and the robot. -
Page 7: Battery Replacement
Battery assembly and replacement Warning! Do not treat electrical appliances as unclassified municipal waste, use separate collection facilities. For information on available collection systems, contact your local government. Do not remove the lithium battery without authorization. When removing the lithium battery from the vacuum device, please remove the ring, bracelet, necklace and watch. -
Page 8: Troubleshooting
Trouble shooting If you have problems with your cleaner, follow the troubleshooting steps below to restore performance. Note: turn off the power before making any repairs. Problem Possible causes Solution The battery is low. Then charge the robot. Turn off the power supply of the robot and visually check whether the impeller rotates. - Page 9 The baffle at the suction cup is like a door The valve of the suction The debris escaped from the to prevent debris from escaping from the nozzle (bottom of the robot. debris chamber. Contact your dealer for cleaner) is broken. replacement parts and instructions.
Need help?
Do you have a question about the Aquajack 600 and is the answer not in the manual?
Questions and answers