Model ..........................standards, regulations and laws. All safety and Serial Number ......................warning information and the operating and installation Register your product www.linarie.com.au instructions must be complied with. TABLE OF CONTENTS 1. General Information ......03 8.5 Using boost function ........12 1.1 Appliance information...
– the mains circuit breaker is switched off, or Do not connect the appliance to the mains electricity – it is switched off at the wall socket and the plug is supply by a multi-socket unit or an extension lead. withdrawn from the socket. www.linarie.com.au...
Switch off and disconnect the appliance immediately. The appliance can get very hot during cooking due to heat rising from the cooktop. Do not touch the housing or the grease filters until the appliance has cooled down. www.linarie.com.au...
Linärie cannot accept liability. Work on electrical components must only be conducted by Please check www.linarie.com.au for more information. trained electrical personnel. 3. DESCRIPTION OF FUNCTIONS Non-return flap...
Make sure the table surface is level and square and that no part interferes with the space required for installation. The kitchen units that are in direct contact with the appliance must be heat-proof (min. 80°C). www.linarie.com.au...
Page 7
Installation is finished. Put the right-angle elbow on the air outlet, and then put the square pipe into the right-angle elbow. Right angle elbow Right angle elbow Square pipe Outer exhaust pipe Skip to [ finishing installation ] www.linarie.com.au...
Put the right-angle elbow on the air outlet, and then put the square pipe into the right-angle elbow. Make a hole with a size of 160mm in diameter in the wall in the direction of the air outlet. Right angle elbow >240 Square pipe >100 www.linarie.com.au...
Page 9
Adjusting the surface of carbon filter cotton by hand. see pic c. aluminum filter carbon filter fixing steel wire Install the aluminum filter Install the air inlet net. All pipes must pass under the base of the pieceof furniture, inside the lift of the kitchen plinth. Aluminum filter www.linarie.com.au...
E: left induction hob control panel F: cooker hood control panel Cooker hood: G: right induction hob control panel 8. ON/OFF 9. On/off indicator light 10. Timer indicator light H: inlet area 11. Timer 12. Digital display 13. Plus button 14. Minus button www.linarie.com.au...
4. Beware of hot surface ‘H’ will show which means cooking zone is too hot to touch. It will disappear when the surface has cooled down to a safe temperature. It can also be used as an energy saving function if you want to heat further pans, use the hotplate that is still hot. www.linarie.com.au...
3. Touch the ‘-’ or ‘slider’ control to set the NOTE: touch the heating zone selection control, timer to ‘00’, the timer is cancelled. the corresponding timer will be shown in the timer indicator. www.linarie.com.au...
Any electrical repairs to this appliance must conform to your local, state and federal laws. Please contact the service center if in any doubt before undertaking any of the above. Always disconnect the unit from the power source when opening the unit. www.linarie.com.au...
When handling a grease filter, be careful not to drop it. and changed regularly, and the cleaning method is This can result in damage to the filter and the cooktop as shown on the right. below. Make sure you hold the filter securely at all times when handling it. www.linarie.com.au...
When contacting Linärie, please quote the model and invalidated, and Linärie cannot accept liability. serial number of your appliance. These can be found on the data plate, after removing the grease filter. Please check www.linarie.com.au for more information. www.linarie.com.au...
Need help?
Do you have a question about the LYON RF9014HOOD and is the answer not in the manual?
Questions and answers