Related Manuals for ChargeArm CA01
Summary of Contents for ChargeArm CA01
- Page 1 Installation Document: Wall mounted ChargeArm English Installation Manual ChargeArm Wall Mount v.1.5...
-
Page 2: Table Of Contents
2. Necessary tools/components ......................4 3. What is in the box? ..........................5 4. Opportunities for mounting accessories ..................... 6 5. Preparing the ChargeArm for installation ................... 7 6. Installing the ChargeArm ........................9 7. Mounting a charge box........................17 8. -
Page 3: Before You Begin
The ChargeArm is only compatible with a 3-Phase – 32A charge cable. • ChargeArm is not responsible for any damage to pipes, walls and other items that may be damaged during the installation of the wall brackets and/or ChargeArm. Installation Manual ChargeArm Wall Mount v.1.5... -
Page 4: Necessary Tools/Components
G. Wall plug suitable for correct type of wall and wood bolt H. Stainless steel flat washer suitable for the wood bolt 8 or 10 mm stainless steel wood bolt with the correct length plug and wall Mounting tool for wood turning bolt K. Pencil Installation Manual ChargeArm Wall Mount v.1.5... -
Page 5: What Is In The Box
4. Countersunk screw M6 x 12 mm 5. ChargeArm cable clamp part 6. Screw : 3 X 12mm 7. ChargeArm cable clamp part 8. Strain relief components 9. Screw : 4 X 10mm 10. Pull Cord Installation Manual ChargeArm Wall Mount v.1.5... -
Page 6: Opportunities For Mounting Accessories
4. Opportunities for mounting accessories There is a vertical groove on the rear of the ChargeArm that has been created to provide easy fixation opportunities for a variety of accessories. The means of fixation to the ChargeArm accessory groove is as follows: •... -
Page 7: Preparing The Chargearm For Installation
5. Preparing the ChargeArm for installation • Do not use a knife or sharp implement to open the box. • When the packaging has been opened, do not discard it but use it as an underlay to further prepare the product. - Page 8 Remount the two packaging buffers as shown in the image below. • Flip the ChargeArm and let it rest on the packaging as shown in the image below. • Mount the included wall brackets ② to the ChargeArm with the sliding nuts ③ and screws ④...
-
Page 9: Installing The Chargearm
The following steps should be carried out with 2 people. • Place the ChargeArm in the desired place against the wall on which it should be mounted. Let the ChargeArm rest on the 2 packaging buffers so that it cannot be damaged and is supported approximately 10 cm above the ground. - Page 10 • Move the 2 wall supports to a position where they find sufficient support for mounting on the wall. • Mark the hole where the top right wall mount should be positioned. Installation Manual ChargeArm Wall Mount v.1.5...
- Page 11 • Remove the ChargeArm from the wall and place it back in the packaging buffers on the cardboard packaging. • Firmly Tighten the 4 screws of the wall supports. Installation Manual ChargeArm Wall Mount v.1.5...
- Page 12 • Drill a hole in the wall in the just-marked spot with the correct diameter and depth for the plug (G) and wood bolt (I) • Insert the plug (G) into drilled hole (A) Installation Manual ChargeArm Wall Mount v.1.5...
- Page 13 • Mount the ChargeArm on the wall with ring (H) and wood bolt (I) in hole A Installation Manual ChargeArm Wall Mount v.1.5...
- Page 14 • Use the spirit level to position the ChargeArm vertically on the wall. • Mark the remaining 3 holes (B, C and D). • Remove the ChargeArm and place it on the unfolded package. Installation Manual ChargeArm Wall Mount v.1.5...
- Page 15 Drill the holes in the wall in the just-marked places with the correct diameter and depth for the plug (G) and the wood bolt (I). • Place the plugs in the drilled holes (B, C and D). Installation Manual ChargeArm Wall Mount v.1.5...
- Page 16 • Mount the ChargeArm on the wall with all 4 rings (H) and wood bolts (I). Installation Manual ChargeArm Wall Mount v.1.5...
-
Page 17: Mounting A Charge Box
7. Mounting a charge box • Mount the charging box at a comfortable height and as close as possible to the ChargeArm. Installation Manual ChargeArm Wall Mount v.1.5... -
Page 18: Opportunities For Mounting Accessories & Interfaces
8. Opportunities for mounting accessories & interfaces There is a vertical groove on the rear of the ChargeArm that has been created to provide easy fixation opportunities for a variety of accessories. The means of fixation to the ChargeArm accessory groove is as follows: •... -
Page 19: Feeding Through And Adjusting The Charge Cable
9. Feeding through and adjusting the charge cable • Spray some Vaseline into the top opening of the arm of the ChargeArm when it is retracted. • Feed the cable through the arm by pushing it. • Park the vehicle to be charged on the desired location near the ChargeArm. - Page 20 Also ensure that the cable moves freely over obstacles that could damage it during use. • Let a certified electrician make the connection of the cable to the charge box. • Mount the strain reliefs as described in part 9. Installation Manual ChargeArm Wall Mount v.1.5...
-
Page 21: Mounting The Cable Clamp, Strain Reliefs And Pull Cord
Tighten the screws ⑨ with a Philips screwdriver until there is no play between the two halves. o Check if the charging cable is firmly secured by the strain reliefs. C. Mount the pull cord ⑩ to the loop present on the arm as shown in the illustration. Installation Manual ChargeArm Wall Mount v.1.5... -
Page 22: Making An Electrical Connection To The Charge Box
11. Making an electrical connection to the charge box The following activities should only be executed by a qualified electrician. • Connect the earth cable which passes out from under the ChargeArm to the electrical installation. • Electrically connect the charge box to the electrical system. -
Page 23: Notes
You may not copy, reproduce, distribute, transmit, modify, create derivative works, or in any other way exploit any part of this material without the prior written permission of ChargeArm b.v.. ChargeArm and all ChargeArm product names and slogans are registered trademarks of ChargeArm b.v.. - Page 24 Directive 2006/42/EG of the European parliament and the council of 17 May 2006 on machinery, and amending Directive 95/16/EC. Haarlem, 21 February 2022 Manufacturer representative: ChargeArm bv ____________________________ Camille van den Brande Installation Manual ChargeArm Wall Mount v.1.5...