Page 17
Controller Manual when the standing table runs to the required height, press the set key (s key), and remember the current height of the lift table. The other two memory keys operate by the same way. The keys 1, 2 and 3 on the manual controller represent that the repeatedly.
Page 18
Controller Manual Display Description Resolvent content Motor 1 fault 1. Check whether the line plug of motor 1 is correctly inserted into the interface of control box; Cause: motor 1 line 2. Check whether the circuit of motor 1 is in good is not connected condition;...
Page 19
Controller Manual Over current fault Reduce load to not exceed maximum load, or of motor 1 remove mechanical fault, press any key to eliminate fault code after 8 seconds to resume operation Cause: overload, (except s key) mechanical failure Over current fault Reduce load to not exceed maximum load, or of motor 2 remove mechanical fault, press any key to eliminate...