Table of Contents
Advertisement
Quick Links
Hartmann - asytec
BELITEC
(Cabinet-Bed-System)
Operating Manual
D:\montage\bedienungsanleitungen\englisch\2020\belitec-be-eng_08-2020.pub
Alfred-Nobel-Straße 9
Tel.: 0 57 32 - 99 22 60
Fax: 0 57 32 - 99 22 61
internet: www.belitec.de
e-mail: belitec@hartmann-asytec.de
Please
destroy older
We do not assume any liability in cases of non-adherence to the assembly manual.
- We reserve the right to make modifications -
The statutory warranty period applies!
32584 Löhne
Rev:
August 08 2020
assembly drawings!
1
Advertisement
Table of Contents
Summary of Contents for Hartmann Asytec BELITEC
- Page 1 BELITEC (Cabinet-Bed-System) Operating Manual Alfred-Nobel-Straße 9 32584 Löhne Tel.: 0 57 32 - 99 22 60 Fax: 0 57 32 - 99 22 61 internet: www.belitec.de e-mail: belitec@hartmann-asytec.de Rev: August 08 2020 Please destroy older assembly drawings! We do not assume any liability in cases of non-adherence to the assembly manual.
- Page 2 Safety instructions Only allow expert personnel who have received the required instruction to assemble the BELITEC system! These advices supports you to avoid dangerous situations and to give confidence in its reliability and for a long life of our product.
- Page 3 Take care of all advices! Liability disclaimer We would like to point out that Hartmann asytec GmbH & Co. KG will not assume any liability for injuries, material damage or other damage caused by failure to adhere to this assembly manual.
- Page 4 3. Components of the system - Cabinet / parts - Mattress - Wooden slats - Carriage unit - Plastic pieces (cam guide) - Motors - Control housing - Emergency lowering - Hand - held switch - misc. assembly pieces (e.g. screws, belts) 4.
- Page 5 5. Electrical connections chain guide (*) The electrical system of controls and drives consists of five components. Plug the main electrical connection (1) into the control block (2). Then plug the block for emergency lowering (3a) into the control block and connect the switch (3b) with housing.
- Page 6 7. Power supply As the main power source BELITEC uses the regular system of 220/110V to supply the steering. There is a transformer built in the control block to change voltage of 220/110 V to ca 30 V to make it not dangerous for people to use the BELITEC.
- Page 7 8. Handling of the bed This manual is used to help for successful and safe handling of the system. to intialize - push the buttons A + B at the same time and hold. - the drives retract the system and stop at the end position. - there is sounding a beep for successful operation.
- Page 8 - Motors and control housing are made with plastics and metalls. - Separate all pieces for recycling to save environment. - It is only allowed to use the Belitec - System in - house. Hartmann - asytec BELITEC (Schrank-Bett-System) Bedienungsanleitung aug-2020...
Need help?
Do you have a question about the BELITEC and is the answer not in the manual?
Questions and answers