Download Print this page

Xiamen Rizheng Industry Crochet Hook Kit Set Assembly Instructions

Crochet Hook Kit Sets Assembly Instructions

Required Accessories

• 7mm, Pen Mandrel

• 9.5mm Drill Bit RZ-DB3/8

• Barrel Trimmer

• 2 pcs Bushings Set RZ-PK285#-BU

• Glue (Thick CA or Epoxy)

• Prepare and cut a blank of 3/4" or larger, to the length of the brass tube (add

1/16" for trimming)

• Drill a 9.5mm hole through the center of the blank.

• Spread glue over the tube, insert into blank with a twisting motion to spread

the glue evenly inside.

• Center the tube inside the blank.

• When glue is dry. Trim the ends of the blank flush to the tube.

• Place the bushings and blank on the mandrel according to Diagram B.

• Thread on the knurled nut and hand tighten to hold all items in place.

• Slide the tailstock to the mandrel shaft, (do not overtighten, it could damage

the mandrel) lock in place.

• Turn the handle ends down, flush with the bushings using the lathe tools,

gradually increasing the grades of sand paper.

• Finish the wood with friction polishing. .

Diagram A

Table of Contents

Do you have a question about the Crochet Hook Kit Set and is the answer not in the manual?

Page 1 Crochet Hook Kit Sets Assembly Instructions Required Accessories • 7mm, Pen Mandrel • 9.5mm Drill Bit RZ-DB3/8 • Barrel Trimmer • 2 pcs Bushings Set RZ-PK285#-BU • Glue (Thick CA or Epoxy) Preparing the Blank • Prepare and cut a blank of 3/4” or larger, to the length of the brass tube (add 1/16”...
Page 2 Assembly • NOTE: Line up the components according to DIAGRAM A. • Press the cap and clip assembly to one end of the tube. • Screw the crochet hook into the crochet hook holder. There are 8 different sizes hooks for your choice. •...