OUTDOOR AIR IKIT Manual

IKIT
Personal Cooling System

Setup / Operation

Name Air Conditioner
Model
Voltage
Electric current DC 4A（MAX）
Power Levels
Battery capacity
Battery Type
Charging time
The below information was intentionally prepared for you.
Please read it.
Health Warning: IKIT personal cooling systems are Not a
substitute for hydration with water, indoor air conditioning, and
wise judgement when navigating personal safety in hot
environments.
Additionally, do not assume that colder is better! The adjustable
levels of the IKIT cooling system are designed to reduce the
effects of high heat to the human body, not eliminate them.
Setting the temperature too low could have negative health
effects. Only adjust for enough cooling power proportionate to
the heat intensity of your ambient environment. 15‐minutes rest
after 1‐hour continuous use is recommended.
Note:
1. Refrigeration module is Not waterproof, Do not pour liquid
directly on any portion of the IKIT system.
2. Condensation buildup is normal on higher power levels.
3. External module fans MUST HAVE UNOBSTRUCTED AIR‐FLOW
to function.
Battery Safety WARNING: If Li‐Ion batteries are incorrectly used,
stored, or charged, they are a fire, burn and explosion hazard. •
Keep the battery out of reach of children • Only charge Li‐Ion
batteries using the charger provided or designed specifically for
your product • Only use Li‐Ion batteries provided with a product
or specifically designed to be compatible. • Allow batteries to cool
for 15 minutes after charging or heavy use. Failure to follow these
instructions may cause overheating or fire • When not in use,
batteries should be stored at room temperature (approximately
20°C/68°F) Avoid contact. If contact accidentally occurs, flush with
water. If liquid contacts eyes, see medical help • DO NOT open,
disassemble, crush, heat above 60°C/140°F or incinerate.
Disposal: Always adhere to national regulations when disposing
of batteries • Do not dispose of batteries with household waste •
Do not dispose of by incineration • Contact your local waste
disposal authority for information on the correct way to dispose
of batteries.
20K010
DC 12V
Button controller should be installed in
the pocket with the clear viewing
4
window and the M button visible.
5000mAh
7AH lithium
4-hours
After charging the battery, insert it into the
pocket next to the button controller and
plug the unit in.
Cooling module

Installation

Manual Control Cooling modules
Front Battery Back
Cable
DC Plug
Controller Battery