Disclaimer Milestone and its affiliated corporations and subsidiaries (collectively "Milestone"), intend to make this manual accurate and complete. However, Milestone makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use of this subject to change without notice or obligation of any kind.
Installation The No. 6 wall brackets are designed to be mounted an 8" bare WARNING: EXPLOSION AND FIRE HAZARD! CUTTING OR concrete block wall, 8" x 8" x 16" bare concrete block wall, or a 2" x DRILLING INTO GAS PLUMBING CAN CAUSE DEATH OR 4"...
Page 6
Installation (continued) Installing to a Concrete Wall 5. Measure down 3-1/2" (88.90mm) from previous drilled hole and drill another 1/2" hole. (See Figure 4) Determine how far up the wall to hang screen. 6. Insert two 1/4-20 Snap Togglers (not supplied) into concrete 2.
Page 7
Assembly Thread hex nut onto 5/16" open eye bolt half way down IMPORTANT NOTE: "S" hooks are intended for one time use thread. (See Figure 6) only. Do not open and re-crimp "S" hooks. 2. Insert open eye bolt through top hole of metal bracket. WARNING: IMPROPER INSTALLATION CAN LEAD TO SCREEN FALLING CAUSING SEVERE PERSONAL INJURY OR Tighten down nylon locking nut on top of bracket.