Aulic Vanity Installation Instruction

Hide thumbs

AULIC

INSTALLATION

INSTRUCTION

CARE, MAINTENANCE AND WARRANTY

IMPORTANT

It is the responsibility of the installer to make any adjustments to doors /

drawers after installation if required. There may have been some movement in

transportation and installation which causes doors/drawers to become unaligned.

Prior to installation it is important to unpackage & inspect your products to ensure

no damage has occurred in transit and that the product IS CORRECT.If damages

has occurred, or a visible defect exists, do not proceed with installation and contact

supplier IMMEDIATELY.

NO CLAIMS FOR DAMAGES / DEFECTS WILL BE RECOGNIZED AFTER INSTALLATION.

vanity

Table of Contents

Need help?

Do you have a question about the Vanity and is the answer not in the manual?

Questions and answers

Summary of Contents for Aulic Vanity

Page 1 AULIC vanity INSTALLATION INSTRUCTION CARE, MAINTENANCE AND WARRANTY IMPORTANT It is the responsibility of the installer to make any adjustments to doors / drawers after installation if required. There may have been some movement in transportation and installation which causes doors/drawers to become unaligned.
Page 2 Wall hung furniture & basins require fixing to a support beam fitted between IMPORTANT TIPS the studs to give a solid wall backing to attach the vanity to. The cabinet should be installed over the top of a tiled wall with adequate clearance for doors and drawers to open.
Page 3 INSTALLATION INSTRUCTION INSTALLATION INSTRUCTION Required Tools Required Tools Step 1 Screwdriver Tape measure Pencil Silicone Electric drill Drill bit(Ø8) Soft Hammer Spirit lever Supplied Spare Part (Ø4.2x60mm) (Ø8X40mm) Step 2 Step 1 Step 2 Silicone Step 3 Step 4...
Page 4 Option two with grey tabs REMOVE DRAWERS Fully extend the drawer. Option One only with screws Undo screws underneath left and right side of drawers connecting to runners. Remove the drawer Locate the grey tabs underneath the drawer. Pull out tabs until you hear a click.
Page 5 Adjusting nut on underside of To adjust the drawer UP To adjust the drawer down (to activate release) and pull about 2cm out from the vanity. closed and connect runners in drawers (backwards tilt) turn anti- (forward tilt) turn clockwise.
Page 6 CARE and MAINTENANCE WARRANTY Aulic products are manufactured from materials that are greatly adapted to bathroom. ALEX GROUP AUS PTY LTD is made to the highest industry standards and quality, However, no abrasive cleaners or wax-based creams are used on any gloss cabinets as referring to table below for warranty periods.