Download
Share
Print this page
Chambrer BD208 Instruction Manual
  1. Manuals
  2. Brands
  3. Chambrer Manuals
  4. Kitchen Appliances
  5. BD208
  6. Instruction manual

Chambrer BD208 Instruction Manual

Dual system draft beer dispenser
Hide thumbs

Advertisement

Quick Links

Download this manual
Model: BD208
InstructIon Manual

Advertisement

loading

Summary of Contents for Chambrer BD208

  • Page 1 Model: BD208 InstructIon Manual...
  • Page 2 TV room when your friends come over to watch the game. Set it on the terrace for the BBQ, or in any other room where the party is going on! The Chambrer Draft Beer Dispenser is especially designed to fit a wide variety of the traditional 5 liter mini kegs which are commonly available on the market.
  • Page 3 rEaD anD saVE tHEsE IMPortant saFEtY InstructIons BEForE usInG tHIs aPPlIancE: When using an electrical appliance, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. Use this appliance only as described in this manual. Other uses not recommended may cause fire, electric shock or personal injury.

  • Page 4: Safety Information

    • Only 16g cartridges are to be used with this appliance as described in this manual Finding a good spot for your chambrer Draft Beer Dispenser: • Place your beer dispenser on a flat surface that is strong enough to support it with a keg.

  • Page 5: Operation

    Your Chambrer Draft Beer Dispenser will keep your 5 litre keg cool for an indefinite period of time. This Draft Beer Dispenser has built-in temperature sensors that have been programmed to automatically keep your beer chilled to 2ºC – 5ºC (37ºF - 42ºF). Therefore, your beer will automatically maintain it’s ideal serving temperature for your consuming pleasure.
  • Page 6 connecting the Keg adapter: 1. Put tap handle on 6. Connect keg adapter beer tap (you will only onto top of the keg, do this step this one pushing down until it time.) clicks into place. 7. Insert blue pin into 2.
  • Page 7 Pressurized tapping system from the Keg. After removing the keg from the Chambrer Draft Beer Dispenser, proceed with the following: Unscrew the white ring from the top of the keg. Remove the blue pin from the hole in the top of the keg.
  • Page 8 KEG oPEratIon Preparing the Keg Before you place your favorite pre-cooled 5 litre keg into the Chambrer Draft Beer Dispenser you must first decompress it! During this procedure be sure not to shake the keg as this will create suds and when piercing the keg the foam will come out.
  • Page 9 10. Once the keg is set in place in the unit, plug in the CO2 inlet tube (which is set at the back of the tap system) into the unit. Be sure the connection is tight from the tube to the unit otherwise CO2 will escape! connecting the co2 cartridge Do not attempt to remove the cartridge again...
  • Page 10 Disconnect the CO2 inlet tube from the tapping system. Push down on white button while pulling out CO2 tube. Carefully lift empty keg out of Chambrer Beer Dispenser using handle on tapping system. Remove tapping system by pulling gently on tab (see picture) and lifting up until the tapping tube has been completely removed from the keg.

  • Page 11: Cleaning And Storage

    clEanInG anD storaGE To maintain the best results and the freshest taste of your beer, the dispenser should be cleaned each time a keg is finished and removed. The drip tray should be cleaned after each session of use. Either daily or weekly to prevent a build-up of beer drippings that could lead to an unpleasant smelling drip tray.
  • Page 12 Chambrer knows or is informed that such damages are possible. It is your responsibility to insure your beer, and take all reasonable, necessary precautions to safeguard its condition.