Advertisement
Quick Links
On-the-Go
Medical Alert User Guide
Read thoroughly: contains important information
Pendant Overview
Red battery light at
top of call button
Blue call light
around call button
To Change From Lanyard to Belt Clip
1. Turn the pendant so the call button faces you. With your
thumb, push the lanyard attachment away from you until the
lanyard clicks off.
2. Place the horizontal piece of the clip on top of the pendant
so that the notches on the pendant and the clip line up.
3. Press the clip into the pendant until it slides securely
into place.
Speaker
Power/battery
level indicator
Microphone
Call button
Advertisement
Related Manuals for Alert1 On-the-Go
Summary of Contents for Alert1 On-the-Go
- Page 1 Pendant Overview On-the-Go Red battery light at Medical Alert User Guide top of call button Speaker Power/battery level indicator Microphone Blue call light around call button Call button To Change From Lanyard to Belt Clip 1. Turn the pendant so the call button faces you. With your...
- Page 2 Set Up & Charging Testing & Calling for Help Important: Fully charge before first use. Test your system every 30 days. ○ Plug in the charging cradle. The red light at the back of the cradle will light up. Press and hold You will hear a message, The Command Center the alert button...
- Page 3 Charged Solid ○ Flash blue every 5 seconds Normal Flash blue every 1 second Out of service* - contact Alert1 While Off Charger ○ Flash every 10 seconds Low battery ○ Flash blue every 5 seconds (GPS + Fall) Device is in active mode.
Need help?
Do you have a question about the On-the-Go and is the answer not in the manual?
Questions and answers