Sharndy ETW29 Installation Manual

WARNINGS Please read the following information before installing and using
your Heated Towel Rack.
- These units should be installed by a certified electrician.
- The unit requires a 120 volt, 60Hz power source and should be installed on a protected circuit.
- Plug-in units should be connected to a grounded outlet with a minimum rating of 10 amps.
- Follow installation instructions to ensure unit is securely fixed to wall.
- Unit is designed for drying towels. Under no circumstances should anybody climb on or hang on unit.
- Unit is intended for indoor use only. Do not place units inside a shower, sauna, steam room, or wherever
unit would be exposed to water.
CAUTION
- As this is a heating device, the surface temperature can increase depending on the ambient temperature
and the towels applied to the unit.
- Overloading the unit will cause the unit to become extremely hot and may result in a burn if touched and/or
damage to towels.
- The fasteners provided with the installation kit are for convenience only and are not suitable for all
installation conditions.
- It is the ultimate responsibility of the installer to ensure suitable mounting hardware is used.
OPERATING INSTRUCTION
- After installation, connect the electric power.
- Remove the protective cover from the switch and turn it to the on position.
- The indicator light will glow red and the towel warmer will start to heat — Allow 10-20 minutes to heat up.
- This towel warmer has been designed to run continuously — Turn off the switch or unplug the cord when
the towel warmer is not in use for long periods of time.
- Never use an extension cord for Plug-in models.
- The towel warmer features an Integrated on/off switch.
- Remove plastic cover after installation.
- Press switch to power on unit.
- Switch will illuminate when on.
CARE & MAINTENANCE
- The unit is constructed from extremely durable stainless steel. To maintain a good appearance, follow
these simple instructions:
- For routine cleaning, simply switch off the unit, allow to cool to room temperature, wipe with a damp cloth.
- Under no circumstances should abrasive cleaners be used to clean the unit.
! CAUTION — SURFACE OF UNIT IS HOT WHEN ON !
INSTALLATION GUIDE
Model:
Voltage: AC120V,60Hz
Power: 40W
Contact us
Email: support@SHARNDY.com
Website: www.sharndy.com
Warranty: Three year limited warranty.With proof of purchase, will apply if all Terms and Conditions of
sale are met and Installation Instructions are adhered to.
! CAUTION — SURFACE OF UNIT IS HOT WHEN ON !
ETW29