REMSleep ResPlus Auto CPAP Quick Start Manual

QUICK START GUIDE
ResPlus Auto CPAP Machine
Model C-20A CPAP/APAP
THIS GUIDE IS NOT INTENDED TO REPLACE THE
MANUFACTURERS MANUAL
STEP 2
As shipped, the device comes as two separate units as shown below:
Control Unit
Depending on user requirements, the two units can be attached
by aligning the pins and pressing the two units together un-
til an audible click is heard. They can be seperated by pressing
the rectangular release button on the back of the humidifer unit.
Humidification Unit
View of back
of unit
Release Button
STEP 1
REMOVE ALL THE COMPONENTS FROM THE BOX
Whats included:
1) Carry Bag
2) ResPlus Blower Unit
3) ResPlus Humidifier Unit
1
2
6
STEP 3
IMPORTANT INFORMATION
THIS UNIT COMES FROM THE FACTORY PRE-SET
WITH THE FOLLOWING PARAMETERS:
MODE - APAP
LOW PRESSURE - 4 cm H2O
HIGH PRESSURE - 10cmH2O
AUTO ON - OFF
AUTO OFF - OFF
IF YOU NEED TO CHANGE ANY OF THESE PRE-SET
PARAMETERS, REFER TO THE MANUAL (Page11)
If the shown presets are acceptable, flip this sheet over
and procede to QuickStart STEP 4.
4) Power cord
5) Hose
6) Manufacturers Manual
7) Replacement filters
4
3
7
5