Table of Contents
Summary of Contents for IR Dor-O-Matic 96000 Series
- Page 1 Dor-O-Matic Series 96000 Slide Control Installation Instructions DOR - O – MATIC ® 7350 W. Wilson Ave. Harwood Heights, IL 60706 Toll Free: 1-800-543-4635 In Illinois: 708-867-7400 Sales FAX: 708-867-0291 www.doromatic.com 96010-084 REV. H December 2002 DA-309...
- Page 2 INSTALLATION Preparation: Refer to Series 96000 Slide Installation Manual (DOM #96000-984) for header preparation instructions. Final Wiring Connections: The Series 96000 header comes from the factory “pre-wired” to minimize installation time at the job site. Connect main power to the terminal block at the end of the header (Figure 1).
- Page 3 FIGURE 2: ACCESSORY WIRING DIAGRAM Operational Check and Adjustments: NOTE: Refer to the latest revision of ANSI/BHMA A156.10-1999 Standard for Power Operated Pedestrian Doors for all settings and adjustments. Sizing: If the 4-Position Switch is used, be sure it is in the “2-WAY” position before proceeding. Apply power to the system using the main power switch on the header/cover.
- Page 4 FIGURE 3: CONTROL BOX & TRANSFORMER BOX ADJUSTMENTS Operational Walk-Through Test: NOTE: It is assumed that during the installation process, any problems would have been found and corrected before this point. However, it is recommended that a complete walk-through test now be performed. Give the system an activation signal.
- Page 5 FEATURES Easy Open: When the door is fully closed and manually opened a few inches, it will automatically open the rest of the way. Adjustable Automatic Reversing: If the door is stalled during the closing cycle, it will automatically stop and reverse to the fully open position. Then the door will close to the point of obstruction and drop to slow speed, looking for the obstruction.
Need help?
Do you have a question about the Dor-O-Matic 96000 Series and is the answer not in the manual?
Questions and answers