Advertisement
Quick Links
Advertisement
Summary of Contents for Dongguan Sunhans Technology SHPRO24G10WANT
- Page 1 Outdoor Wireless Bridge System SHPRO24G10WANT Quick Installation Guide V1.0 Issue 01 Date 2021-6-22...
-
Page 2: Part List
Part List Please check the part list before the installation: Wireless AP Power Adapter for AP Network Cable Quick Installation Guide Active Antenna DC injector 24V DC adapter for Antenna Outdoor wall fixing accessories ... -
Page 3: Software Configuration
Software Configuration 1. Log in to the management interface Before logging in to the management interface，first set the computer’s local connection IP 192.168.8.X, X is any integer from 2-253，subnet mask is set to 255.255.255.0.Refer to the figure below Open the browser，visit http://192.168.8.1, log in to the management interface，original log in password is ：... - Page 4 After successfully logging in, you will enter the main menu of the system, as shown in the figure below. 2. Bridge mode configuration 1) Enter “Configuration Wizard” and select “Bridge” mode 2) Click “AP Mode” to set according to the prompt steps, and click “Save” after the setting is completed...
- Page 6 3) Take another APG721 and enter the setting interface according to the above steps, click “Station” to set according to the prompt steps, and click “Save” after the setting is complete...
- Page 7 Note：the IP address of the Station needs to be different from the IP address of the main AP Click “Scan” and select the main AP for bridging settings. After the bridge is successfully connected, the main AP can perform point-to-point WiFi signal transmission with the Station AP 3.
- Page 8 2) Follow the steps prompted to set the AP mode, and click “Save” after the setting is complete...
- Page 9 4. Repeater mode description 1) Enter “Configuration Wizard” and select “Repeater” mode 2) Follow the steps prompted to set the Repeater mode, and click “Save” after the setting is complete...
- Page 10 5. Ro uter mode configuration 1) Enter “Configuration Wizard” and select “Router” mode...
- Page 11 2) Follow the steps prompted to set the router mode, and click “Save” after the setting is complete...
- Page 12 FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Need help?
Do you have a question about the SHPRO24G10WANT and is the answer not in the manual?
Questions and answers