Page 1
Installation and Specification 1. General: The MR-DT integrates a 2 line x 16 character back-lit LCD display with a 16-position keypad and a reader port. This highly functional I/O device can communicate to the system controller via a 2-wire RS-485 interface.
Page 2
Disble software configuration at startup NOT USED DIP1: Proper termination practices must be followed to insure proper operation. If the MR-DT is the last device on the RS-485 bus, termination should be set to ON. DIP2: Used for testing. This DIP forces the baud rate and address to a known value.
Page 3
NO to "save settings" will return you to the first screen of the configuration menu. 4. Status Display: The MR-DT can display a status report which allows the user to confirm the settings, read back the serial number, firmware revision number, and hardware settings. It also displays communication status as on- line or off-line.
Page 4
This product is not intended for, nor is rated for operation in life-critical control applications. Imron Corporation is not liable under any circumstances for loss or damage caused by or partially caused by the misapplication or malfunction of the product. Imron Corporation's liability does not extend beyond the purchase price of the product.