Summary of Contents for FLEET HOSTER FleetFlix AI+ Pro
-
Page 8: Alert Button
LED Indicator States Camera Start/Bootup Live Stream All 3 lights flash (Red, Orange, and Green) Flashing Green Firmware Update Stand By All 3 lights flash (Red, Orange, and Green) Solid Red Offline Camera Online and Recording No Lights Solid Green Camera Online and Not Recording Red and Orange Alert Button... -
Page 10: Installation
� rL __ Tt-lDSTE� FLEETFLIX /\I+ INST/\LL/\TION GUIDE Installation This chapter provides information about the Fleetflix Al+ installation procedures. Removing the Right Panel 1/0 Cover Step 1 Loosen the screw of the right panel 1 / 0 cover with the included alien wrench. - Page 11 � rL __ Tt-lDSTE� FLEETFLIX /\I+ INST/\LL/\TIDN GUIDE Step 2 Remove the right panel 1 / 0 cover. panel 1 / 0 cover Removing the right Installing the Micro SD Card (As needed) T he Fleetflix Al+ dash cam supports automatic video recording to a Micro SD card after startup. To use this feature, you need to insert a Micro SD card into the Micro SD card slot on the Fleetflix Al+.
- Page 12 � rL __ Tt-lDSTE� FLEETFLIX /\I+ INST/\LL/\TION GUIDE Installing the 4G Micro SIM Card (As needed) The Fleetflix Al+ dash cam can download maps through a 4G network. To use this feature you need to insert a 4G Micro SIM card into the Micro SIM card slot on the Fleetflix Al+. Step 1 Locate the Micro SIM card slot.
- Page 14 � rL __ Tt-lDSTE� FLEETFLIX /\I+ INST/\LL/\TION GUIDE Step 3 Select the appropriate Blade Fuse Holder cable. Plug in the ACC fuse that was removed from the fuse box into the Blade Fuse Holder cable, and then plug in the other ACC fuse that we provided. Installing the ACC fuses on the blade fuse holder cable Step 4 Plug in the Blade Fuse Holder cable into the ACC fuse slot in the fuse box.
- Page 16 � rL __ Tt-lDSTE� FLEETFLIX /\I+ INST/\LL/\TION GUIDE Step 9 Connect the other end of the OBD II Power Cable to the Blade Fuse Holder cable as shown in the diagram below. OBD II Power Cable Connections Diagram Blade Fuse Holder Cable •lEJ§gj@§! �...
- Page 18 � rL __ Tt-lDSTE� FLEETFLIX /\I+ INST/\LL/\TION GUIDE Mounting Step 1 Attach the optional suction cup or the adhesive tape mounting bracket onto the Fleetflix Al+. Optional Adhesive Tape Suction Cap Mounting Bracket Mounting Bracket Installing the mounting bracket Step 2 Install the Fleetflix Al+ onto the center of the wind shield (preferably below the rear view mirror).
- Page 19 After installing the camera, the following measurements are needed Hood length - the distance from the front lens of the camera and the front bumper Vehicle width - the total width of the vehicle at its widest point in front of the camera (typically wheel arch to wheel arch) Camera height - the distance from the ground to the bottom of the camera Driver position - which side of the vehicle the steering wheel is on, (left hand is typical for American market vehicles)