NQD 757-4WD29 Instruction Manual

NQD
Product ID
757-4WD29
Remote Layout
One-click Twist
Short Press
for Auto
Demo, Long
Press for Mute
All-round
Moving
Four Azimuth
Side Drifts
Watch Sensor Control
1. Fist rises vertically, body twist rises
2. Fist goes down vertically, body twist is reduced
3. Fist leaned forward, the car forward
4. Fist leaned back, the car backed
5. Fist leaned left, the car drifted left / rotated
counterclockwise in place
6. Fist leaned right, the car drifted right / rotated
clockwise in place
7. Short press the finger button to switch modes
(horizontal run / rotate), long press to mute
2.4G automatic pairing frequency
1.Install the batteries inthe remote control, and the remote control indicator will
start flash. Then install the battery in the rc car and turn on the switch to start
the connection. When the connection is successful, the remote control indicator goes
off. (Please repeat the above operation if the connection fails)
2. Each remote control can only be connected to one rc car. When the connection is
successful, each car will not interfere with each other. (Do not connect multiple cars
at the same time)
3.If the remote control does not detect the 2.4G signal from the remote control car
after one minute, the power indicator flashes, you must restart the power switch to
pair the frequency.
4. When you need to pair with other models of remote control or remote control car,
you need to turn off the power of the remote control and remote control car to re-pair.
Precautions
The battery charger using this toy must be checked regularly to prevent damage to the
wires and other parts. If it is damaged, it must be used after the damage is repaired
Instruction Manual
Twist Up/Down
Product Name
Programming key (press
for three seconds
to start recording,
tap to start
presentation)
Rotate Left/Right
Indicator Light
Gesture Remote Control Car
On/Off
Signal
Light
Finger Button