Elite Cedar 2436BS Assembly Instructions

Assembly Instructions
Stain your cedar planters for protection from the sun's UV rays. If you want to
retain the natural cedar look, there are some clear or "neutral" stains on the
market designed strictly for protection without colorization. Just make sure the
stain you select contains UV inhibitors. UV damage is one of the leading causes of
cedar wood discoloration, leading to a gray, washed-out look.

Tools Required

: Changeable bit Screwdriver or electric Drill (Bit included in this Kit).
Growing Medium: 4.3 CuFt (not included)

Parts

(4) Legs
(8) Slats (1 has pre-drilled holes)
(2) Long Panels (Slat Supports)
(2) Short Panels (NO Slat supports)
(4) Corner Caps
(1) Bottom Shelf
(1) Wood Block

Hardware

(1) Special Screw driver Bit
(9) Small (1 ¼") screws
(4) Medium (2") screws
(4) Large (2 1/2") screws
(1) Liner (gray fabric)
Elite Cedar
Elevated Planter #2436BS
for
NOTE 1:
All holes are pre-drilled and screws are included.
*DO NOT overdrive screws
**Be Careful not to discard any parts with packaging.
NOTE 2:
Cedar has a "finished side and edge" that should always face outward
and upward. Identify the non-finished side (circled item in image
below highlights non-finished area).
Notice the top "finished edge" is placed
upward and the non-finished side
inward so it is covered by the growing
medium.
TM
Planters
Slat Support
(Inside)