Table of contents Table of contents Contents ......................2 General information ..................4 Reading and storing the user manual ..............4 Proper use ........................4 Explanation of symbols ................... 4 Safety ....................... 5 Explanation of notes ....................5 General safety notes ....................5 Product description ..................10 First use ......................
General information General information Reading and storing the user manual This user manual accompanies this Ultrasonic Cool Mist Humidifier (referred to below only as the ‘product’). It contains important information about start-up and handling. Before using the product, read the user manual carefully. This particularly applies to the safety instructions.
Safety Clean the water tank every three days. The filter must be cleaned or replaced on a regular basis. Safety Explanation of notes The following symbols and signal words are used in this user manual. This symbol/signal word designates a hazard with a moderate degree of risk which may lead to WARNING! death or severe injury if not avoided.
Page 6
Safety − Do not open the housing; have qualified professionals carry out repairs. Contact a qualified workshop for this. Liability and warranty claims are waived in the event of repairs performed by the user, improper connection or incorrect operation. − Only parts that comply with the original device data may be used for repairs.
Page 7
Safety WARNING! Danger for children and persons with impaired physical, sen- sory or mental capacities (e.g. disabled persons, older persons with reduced physical and mental capacities) or lack of experi- ence and knowledge (e.g. older children). − This product may be used by children aged eight years and over and by persons with impaired physical, sensory or men- tal capacities or those lacking experience and knowledge if they are supervised or have been instructed in how to use...
Page 8
Safety Only use the product periodically if you cannot reduce the release of vapour. Do not let absorbent materials (e.g. carpets, curtains, drapes or tablecloths) get wet. − Do not leave any water in the water tank when the product is not in use.
Page 9
Safety − Never add water to the product’s vapour discharge opening or vapour discharge channel. Wipe wet areas on the product with a dry cloth. − Do not put any metals, chemicals or cleaners in the water tank. Otherwise, humidification won’t work properly. −...
Product description Product description The product is used for raising humidity in interior spaces. The control unit uses ultrasonic sounds to atomise the water filled in the water tank into the finest drop particles and then the vapour discharge channel releases them into the ambient air as vapour or mist through the vapour discharge opening ...
First use First use Checking the product and package contents NOTICE! Risk of damage! If you do not take care when opening the packaging with a sharp knife or other pointed object, the product can quickly become damaged. − Be very careful when opening. 1.
Operation NOTICE! Risk of damage! The product can be quickly damaged when used with an empty water tank. − Never use the product without water in the water tank. • It is best to use the product with cool boiled or distilled water. •...
Operation 4. Turn the water tank cap clockwise to put it back on and wipe off any remaining water with a dry cloth. 5. Put the water tank with the vapour absorption unit facing downwards onto the control unit Water tank Water level window Water tank opening Vapour absorption...
Operation Switching the product on and off The product has three levels of humidification. Press the Power touch key change the levels of humidification (see Fig. C). Based on the level selected, the Power touch key will illuminate a certain colour. Colour Level of humidification High...
Operation Refilling with water The built-in safety mechanism automatically stops the humidification process when there is no water in the water tank. The Power touch key flashes red and vapour is no longer released from the vapour discharge opening. 1. To use the product again, pull the mains plug out of the socket and add water to the water tank (see ‘...
Cleaning 6. Place the lid back on the water tank. Essential oil tray Vapour discharge channel Water tank Essential oil pad Cleaning WARNING! Risk of electric shock! Water or other liquids that have penetrated the housing may cause an electric shock. −...
Cleaning ing to the instructions provided in the ‘Cleaning’ chapter. Any deposits, residues or dirty film that have formed on the water tank’s surfaces or inner surfaces must be removed. All surfaces must be rubbed dry. NOTICE! Risk of short circuit! Water or other liquids that have penetrated the housing may cause a short circuit.
Cleaning Cleaning and descaling the water tank 1. Unscrew the water tank cap from the water tank and remove any deposits or dirt particles that have collected in the water tank (see Fig. B). Wipe off limescale deposits with a damp cloth and, if necessary, use a little vinegar to dissolve the limescale.
Maintenance Control unit Bottom cap Bottom opening Dust filter Maintenance Changing the silver ion ball filter • The silver ion ball filter ensures that there are no germs in the stagnant water. • The silver ion ball filter should be replaced after 160 hours of oper- ation.
Storage − We will advise the charges for your order, including postage. 1× 3 pcs. set spare filters $8.95 AUD + $2.20 AUD postage. − After you confirm the order a payment request via PayPal will be initiated. You will receive an email from PayPal with payment instructions. If you do not have a PayPal account, you do not need to register, simply a credit card and email address is needed.
Troubleshooting Troubleshooting Problem Possible cause Solution The touch keys / The mains plug − Insert the mains plug do not illuminate. has not been inserted the socket. No vapour is properly. released. The product is not − Press the Power touch switched on.
ULTRASONIC COOL MIST HUMIDIFIER Warranty Details REGISTER YOUR PURCHASE AT www.aldi.com.au/en/about-aldi/product-registration/ TO KEEP UP-TO-DATE WITH IMPORTANT PRODUCT INFORMATION The product is guaranteed to be free from defects in workmanship and parts for a period of 12 months (dependant on product) from the date of purchase. Defects that occur within this warranty period, under normal use and care, will be repaired, replaced or refunded at our discretion.
Please be assured though, refurbished parts or replacements are only used where they meet ALDI’s stringent quality specifications. If at any time you feel your repair is being handled unsatisfactorily, you may escalate your complaint.
Page 25
ALDI guarantees that our exclusive brand products are developed to our stringent quality specifications. If you are not entirely satisfied with this product, please return it to the nearest ALDI store within 60 days from the date of purchase, for a full refund or replacement, or take advantage of our after sales support by calling the supplier’s Customer Service Hotline.
Need help?
Do you have a question about the Stirling HTJ-2108-W and is the answer not in the manual?
Questions and answers