enviro-tech ET3-12 Installation

ET3-12 URINAL FLUSH VALVE - TROUBLESHOOTING YOUR INSTALLATION

Initial Checks:

• C
HECK WATER SUPPLY
• U
NPLUG ALL CABLES
)
TO RESET BEFORE RECONNECTING EVERYTHING CAREFULLY AND CORRECTLY
RECONNECT BATTERY BOX TO TRANSFORMER BEFORE SENSOR CABLE
W –
ARNING
• E
NSURE SCREWED COLLAR CONNECTIONS ARE TIGHT
• C
HECK SENSOR WINDOW IS CLEAN AND UNOBSTRUCTED
• I
F URINAL HAS BEEN OPERATING CORRECTLY FOR SOME TIME AND HAS SUDDENLY STOPPED OR
WATER IS CONSTANTLY RUNNING ON
,
BATTERIES
/
SUPPLY OUTLET
• I
F URINAL STILL DOES NOT FLUSH
/
DEBRIS BUILD UP CAN PREVENT SOLENOID FROM OPENING AND CLOSING CORRECTLY
• I
F NEW INSTALLATION
ACCORDANCE WITH THE INSTALLATION MANUAL
CONNECTIONS AND ENSURE BATTERIES HAVE BEEN INSTALLED CORRECTLY
• I
F RED LIGHT IS INDICATING AND YOU CAN HEAR THE SOLENOID CLICKING
COMING OUT
;
,
LEAVE UNPLUGGED FOR
ELECTRONICS WILL BE DAMAGED IF CONNECTED INCORRECTLY
.
UNIT SHOULD FLUSH THIS WILL ALSO HIGHLIGHT ANY FAULT WITH POWER
(
IF MAINS POWERED
–
CLEAN SOLENOID VALVE AND INLET FILTER
–
CHECK THAT FLUSH VALVE HAS BEEN INSTALLED CORRECTLY
–
CHECK WATER SUPPLY IS CORRECT AND WATER IS TURNED ON TO THE URINAL
5 (
MINUTES THIS GIVES THE ELECTRONICS A CHANCE
(
DO NOT OVERTIGHTEN
;
–
LIKELY CAUSE IS NO POWER
);
.
IF NO LIGHTS ON SENSOR
–
IF MAINS POWERED
( ).
SEE DIAGRAM BELOW
*;
);
. -
TO CONFIRM CHANGE
. (
FINE PARTICLE
);
,
IN
–
RECHECK ALL
.
,
BUT NO WATER IS
:
;