Download Print this page

Jen Woodhouse Bunk Buddy Quick Start Manual

Download this manual

Materials:

• Scrap ¾-inch Plywood (at least a 20" x 15" piece)

• Scrap ¼-inch Plywood (at least a 10" x 15" piece)

• 1 ¼-inch Brad Nails

• 1-inch Brad Nails

• Wood Glue

• Wood Filler

Tools:

• Tape Measure

• Pencil

• Carpenter's Square

• Table Saw

• Jig Saw

• Brad Nailer or Hammer

Cut List:

• (2) ¾-inch plywood @ 10 inches x 5 ½ inches (sides)

• (1) ¾-inch plywood @ 12 ½ inches x 5 ½ inches (bottom)

• (1) ¼-inch plywood @ 14 inches x 6 inches (back)

• (2) ¼-inch plywood @ 14 inches x 1 ½ inches (front slats)

Page 1 Materials: • Scrap ¾-inch Plywood (at least a 20” x 15” piece) • Scrap ¼-inch Plywood (at least a 10” x 15” piece) • 1 ¼-inch Brad Nails • 1-inch Brad Nails • Wood Glue • Wood Filler Tools: • Tape Measure • Pencil • Carpenter’s Square • Table Saw • Jig Saw • Brad Nailer or Hammer Cut List: • (2) ¾-inch plywood @ 10 inches x 5 ½ inches (sides) • (1) ¾-inch plywood @ 12 ½ inches x 5 ½ inches (bottom) • (1) ¼-inch plywood @ 14 inches x 6 inches (back) • (2) ¼-inch plywood @ 14 inches x 1 ½ inches (front slats)
Page 2 Bunk Buddy (Bunk Bed Shelf) – Copyright © 2018 Jen Woodhouse | The House of Wood STEP 1 – BUILD THE TWO SIDES Measure, mark, and cut sides and bottom to size. Use a jigsaw to cut the curve in the sides. Attach the sides to the bottom with 1 ¼-inch brad nails and wood glue. www.JenWoodhouse.com...
Page 3 Bunk Buddy (Bunk Bed Shelf) – Copyright © 2018 Jen Woodhouse | The House of Wood STEP 2 – ATTACH THE BACK Measure, mark, and cut back to size. Attach as shown with 1-inch brad nails and wood glue. www.JenWoodhouse.com...
Page 4 Bunk Buddy (Bunk Bed Shelf) – Copyright © 2018 Jen Woodhouse | The House of Wood STEP 3 – ATTACH THE FRONT SLATS Measure, mark, and cut front slats to size. Attach as shown with 1-inch brad nails and wood glue. Fill nail holes, sand, stain and/or paint, and finish as desired. Attach bunk bed ladder hooks to the back with screws. www.JenWoodhouse.com...