Page 2
IRZ1ZT92 Copyright Statement ZiFiSense owns the copyright on this specification. No part of this specification may be reproduced in any form or means, without the prior written consent of ZiFiSense. Disclaimer This specification is preliminary and is subject to change at any time without prior notice.
IRZ1ZT92 1. Product Description ZETA Motion Sensor is a low power infrared sensor which can sense human movements with its high-sensitivity amplifiers, anti-jamming devices, and differential inputs, so that the false detection is avoided. 2. Applications Rooftops, computer rooms, important equipment rooms, illegal entry detection, operating position detection.
IRZ1ZT92 4. Product parameters Product No. IRZ1ZT92 Transmission protocol ZETA Sub-GHz, adjustable according to Frequency band Wireless Features local regulations 20dBm max, adjustable according Output power to local regulations Power supply Battery, 2*ER14505 Battery capacity 2*2700 mAh Electrical Features Stand-by current ≤...
IRZ1ZT92 6. Installation There are three installation methods: Screw, 3M Adhesive and cable ties. 6.1. Screw 6.1.1.Auxiliary material Materials Quantity self tapping screw (M3*20) 2/device #4 expanded plastic pipe Percussion drill,#4 drill bit,hammer slotted screwdriver, cross screwdriver Open the device case 6.1.2.Installation instructions Use a slotted screwdriver to open the top cover from the bottom edge.
Page 7
Use the self-tapping screws to secure the device in the mounting position. IRZ1ZT92 mounting hole mounting hole Power on Insert the power plug into the upper power socket, install two 14505 batteries (remove the insulation sheet for the existing battery), and close the upper cover.
IRZ1ZT92 6.2. Adhesive 3M 6.2.1.Auxiliary material Materials Quantity 3M seamless thickened double-sided adhesive Slotted screwdriver, utility knife Installation position 6.2.2.Installation instructions Select a flat mounting position, and clean it up. Open the device case Use a slotted screwdriver to open the top cover from the bottom edge. opening ...
IRZ1ZT92 power socket Adhesive device Take the appropriate amount of 3M adhesive, attach it to the back of the sensor, remove the protective film of the 3M adhesive, and install the device to the specified position. 6.3. Cable Ties 6.3.1.Auxiliary material Materials Quantity...
Page 10
IRZ1ZT92 opening Fixation Pass the 2 cable ties through the device and secure to the installation rod Installation position...
Page 11
IRZ1ZT92 Power on Insert the power plug into the upper power socket, install two 14505 batteries (remove the insulation sheet for the existing battery), and close the upper cover. power socket...
IRZ1ZT92 7. Use of Device The sensor detection distance is about about 3 meters without occlusion. The detection is based on the amount of change in infrared detection to determine whether there is the motion, so it is unable to detect a stationary person.
Page 13
FCC WARNING Any Changes expressly or modifications not approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. ...