Cerillo STRATUS Quick Start Manual

Your new Stratus is an L.E.D.-based plate reader used to measure
optical densities in standard plate formats.
Stratus (1)
Step 1: Get Started.
microSD card may already be installed in the Stratus.
Step 2: Location. Place your Stratus where you'd like to measure. This is anywhere your
samples will be happy – incubator, anaerobic chamber, benchtop, hood, etc.
Step 3: Power the Device. First, insert the microSD card. Then, plug the power adapter into
a standard wall outlet, and the USB cable into the power adapter and the Stratus.
Step 4: Allow for Equilibration.
mental conditions. This can be a good time to do your experimental prep work.
Step 5: Go! (See reverse.)
Important Notes
1. The Stratus should only be used with the provided USB 2.0 cable. The Stratus is not
compatible with USB 3.x cables.
2. Additional technical information is provided at cerillo.net.
microSD card (1)
Confirm receipt of all components and device (shown above). The
The Stratus needs 60 minutes to equilibrate to new environ-
support@cerillo.net
cerillo.net
Quick Start Guide
STRATUS
Stratus Components
USB Cable (1) Power Adapter (1)