Advertisement
Quick Links
Advertisement
Related Manuals for Jereh JES-HS60
Summary of Contents for Jereh JES-HS60
- Page 1 JES-HS60 Handheld Electrostatic Sprayer Filter Replacement & Nozzle Cleaning USER GUIDE...
-
Page 2: General Description
General Description Given the bottle is full of liquid during normal spraying, if the spray volume is reduced, the filter may be blocked and it needs to be replaced; if the atomization effect of spray is getting poor or the nozzle does not perform the spraying, the nozzle may be blocked and it needs to be cleaned. - Page 3 clean to prevent impurities from affecting the liquid pump performance. 3. Screw on the bottle again, and the filter replacement is completed.
- Page 4 Instructions of Nozzle Cleaning Steps 1. Spray clean water for one minute to rinse the liquid in the hose, then take off the bottle; remove the nozzle cap by rotating counterclockwise with the nozzle cap removal tool in accordance with the assembly diagram, and then take out the nozzle.
- Page 5 3. Carefully scrape off the debris and stains on the nozzle with a needle, especially those foreign matters in two grooves on the inner side of nozzle. After scraping, rinse the components in the nozzle assembly diagram with clean water. 4.
- Page 6 5. According to the assembly diagram, screw on the nozzle cap onto the sprayer by rotating clockwise with the nozzle cap removal tool. When replacing, to ensure the sealing effect, make sure that the black rubber pad is coaxial with the nozzle. It is recommended to install the nozzle in the vertical direction of the spray gun as shown below, which makes it easier to achieve that the black rubber pad is coaxial with the nozzle.