Advertisement
Advertisement
Table of Contents
Summary of Contents for Dunlin Campaign Safari
- Page 2 A. Two Rear Legs. Identifiable by small drill hole in top block of each leg. B. Four support bars. C. Two Sling Braces. D. Two Front Legs. E. Two cotton ropes. Long for Wide Sling. Short for Narrow Sling. F.
- Page 3 Turn Front Legs and Rear Legs upside Rotate assembled chair frame so its down on a soft rug or carpet. standing. Insert the four support bars into the drilled holes on the Front and Rear Legs Loop the narrow sling between the left and Loop the wide sling between the front and right support bars.
- Page 4 J. Sling shown with cutout K. Nut Ensure H. Hex Head Bolt is recessed into Rear Legs. Insert the two sling braces, C, into the back sling, aligning the drill holes in the sling braces with the opening in the back sling. Push the hex head bolt into the Rear Leg until it is recessed, a small rubber hammer may help here.
- Page 5 I. Arm Strap L. Washer A. Rear Leg L. Screw L. Chrome Cap Take one of the Arm Straps and position the one end of the straps metal eyelet over the recessed thread in the Front or Rear Leg. Insert the screw through the washer and then insert the screw through the Arm Strap metal eyelet.
Need help?
Do you have a question about the Campaign Safari and is the answer not in the manual?
Questions and answers