Direct Wicker SICILY Assembly Instructions

TABLE
ASSEMBLY INSTRUCTIONS
BEFORE YOU START ASSEMBLING YOUR
FURNITURE:
CHECK THAT YOU HAVE ALL THE
PIECES LISTED ON THE LEFT HAND
SIDE.
LAY A CLEAN SHEET ON A FLAT
SURFACE BIG ENOUGH TO ASSEMBLE
YOUR FURNITURE ON IN ORDER TO
PROTECT YOUR FURNITURE.
A 1
B 1
C 1
D
1
E 11
F 1
G 1
TABLE ASSEMBLY INSTRUCTIONS . DIRECT WICKER
1.
Lay the table top (A) down so the frame is facing upwards. With the slit facing
upwards, attach chair legs (B), to the table top by aligning the screw holes
withthose in the table top (A) . Insertscrews (E) throughthe washerand into
theholesandlooselytightenwiththeallenkey(F).
Theninserttableleg(C)intopositionovertheslitoftableleg(B)andalignthe
screwholeswiththeholesinthetabletop(A).Insertscrews(E)throughthe
washerandintotheholesandlooselytightenwiththeallenkey(F)in the
locationsshownin theimagebelow.
2.
Attach both the table legs together by placing the bracket (G) over the screw
holes on the bottom of table leg (B & C) as shown in the above image and
inserting the three remaining screws (E) through the washers and into the
bracketandtablelegs.Fullytightenusingtheallenkey(F).
Fully tighten all of the screws in the table using the allen key (F) then place the
screwcapsoverallofthescrews.