Advertisement
Quick Links
Tag360-SBM is a Bluetooth Low Energy (BLE) "Smart Bike Module" intended as an add on
attachment to vehicles, thus allowing the vehicles to be immobilised using associated Keyfob
device, TAG360-KF, or via a mobile app.
Tag360-SBM uses Bluetooth Low Energy (BLE) to get mobilize or immobilise commands from
TAG360-KF, or from mobile app. These commands are passed on to vehicle's engine control
unit (ECU) via a digital bus, e.g. CAN. Tag360-SBM is powered by vehicle's battery. A backup
battery of 12V is provisioned within the unit.
Features
•
BLE 4.2/5.0
•
Secured via Authentication and
(optional) 128b AES encryption
Tagbox
contactus@tagbox.co
•
Mobilise/Immobilise vehicle
•
Enhanced vehicle security
•
Last parked location
Copyright
2019
Tag360-SBM
Applications
contactus@tagbox.in 1
Advertisement
Summary of Contents for Tagbox Tag360-SBM
- Page 1 Tag360-SBM uses Bluetooth Low Energy (BLE) to get mobilize or immobilise commands from TAG360-KF, or from mobile app. These commands are passed on to vehicle’s engine control unit (ECU) via a digital bus, e.g. CAN. Tag360-SBM is powered by vehicle’s battery. A backup battery of 12V is provisioned within the unit.
-
Page 2: Specifications
Tag360-SBM Specifications Electrical and Radio Specifications Bluetooth Low Energy, BLE 5.0 Radio Vehicle 12V battery Power Interface Custom 1-wire interface to TCI unit Mechanical Specifications Dimensions 66.5mm*56mm*26mm Block Diagram Tagbox Copyright 2019 contactus@tagbox.in 2 contactus@tagbox.co... -
Page 3: Connector Pinout
Tag360-SBM Connector Pinout PIN # DESCRIPTION GROUND BATTERY IGNITION Installation Instructions Step1: The SBM unit needs to be mounted on vehicle through its special clamp, as shown in drawing below. The clamp inserts into rubber boot, thus securing the SBM unit to the vehicle. - Page 4 Tag360-SBM Step2: Connect the SBI connector output to TCI Unit. The SBM connector output is a 6 pole Besmak connector-Male, which connects with corresponding 6-pole female connector of TCI unit. Step 3: The SBM unit is supplied with a pre-paired Tag360-K1 Keyfob unit. The unit has identification QR...
- Page 5 Tag360-SBM After installation of SBM unit, the vehicle can be mobilised or immobilised via the keyfob unit. Step 3.1: Turning on the vehicle a. Keyfob unit should be in Bluetooth range of the vehicle. It is recommended that the keyfob should be within 5 meters from the vehicle b.
- Page 6 Regulatory Information TAG360-SBM comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) these devices may not cause harmful interference, and (2) these devices must accept any interference received, including interference that may cause undesired operation.