Carpe Iter Holder Instructions Manual

Hide thumbs

1. Carpe Iter Holder

1.1. The Carpe Iter Holder is speciﬁcally designed for the Ci Pad. Do not use the Holder for any

other equipment than the Device.

1.2. The Holder will ensure secure mounAng and will also provide conAnuous charging for the

Device through the maAng pads on the back on the Device.

1.3. The Holder includes a power source that was designed speciﬁcally for the Device. DO NOT

use the power source to power any other equipment than the Device.

1.4. DescripAon:

1.5. Holder installaAon requires at least basic mechanical and electrical skills. If you are in doubt,

have the Holder installed by a professional workshop.

1.6. Protect the charging pins in the Holder from mechanical damage. Especially take care when

inserAng the Device into the Holder not to hit the charging pins with the Device – they

could be damaged inside even if you cannot see any damage with naked eye. Damaged

charging pins will cause charging problems (no charging or insuﬃcient charging).

1.7. Protect the charging pins from being connected to one another with electrically conducAve

materials.

1.8. MounAng Holder

1.8.1.

The base plate of the Holder contains 6 nuts for M5 screws. Screws are not

included.

1.8.2.

The mounAng nuts create a standard AMPS hole paTern (30x38mm) in the

landscape orientaAon.

Table of Contents

Need help?

Do you have a question about the Holder and is the answer not in the manual?

Questions and answers

Summary of Contents for Carpe Iter Holder

Page 1 1. Carpe Iter Holder 1.1. The Carpe Iter Holder is speciﬁcally designed for the Ci Pad. Do not use the Holder for any other equipment than the Device. 1.2. The Holder will ensure secure mounAng and will also provide conAnuous charging for the Device through the maAng pads on the back on the Device.
Page 2 Excessive vibraAons and shocks in the Holder might cause a premature failure of the charging pins and / or of the Device. This applies especially, if you plan to use the Holder and the Device oﬀ the paved roads.
Page 3 Correct Device placement / orientaAon in the Holder (M8 charging connector is facing away from the spring-loaded retaining hook): 1.9.2. Never put the Device into the Holder in any other orientaAon than indicated above. It will prevent charging through the Holder and it will damage hardware buTons.
Page 4 Device for proper alignment, check that port ﬂaps are closed properly and try again. 1.9.3.6. using the lock in the Holder is opAonal (the Device will not fall out of the Holder even when the lock is not engaged).
Page 5 All those items are available as spare parts. 2. Power source 2.1.1. The power source included with the Holder contains 1 set of input wires and 2 connectors on the output. The output connectors may be connected to the Holder and M8 charging cable simultaneously:...
Page 6 2.1.2. M8 charging cable must NOT be connected to a second power source, when charging the Device from both the Holder and M8 charging connector, or it will damage or destroy the Device. 2.1.3. The power source requires direct current (DC) input with voltage exceeding 13,1V.
Page 7 2.1.15. DO NOT change the stock connectors on the power source’s output leads. Any tempering with wires and connectors on the output will void your warranty for both the Holder and the Device and we will NOT provide any assistance with debugging possible issues in such case.