Download Print this page

Balgo 1188EP Installation Manual

Instant shower with dc booster pump

Advertisement

Quick Links

SPECIFICATION :
Power
Min Water Pressure
Max Water Pressure
Water Connection
Water Temp Control
Water Pressure Control
Product Dimensions
Box Dimensions
FEATURES :
- Preferred temp control setting with easy to use step less variable electronic control
- DC Booster Pump for low water heads
- Suitable for low & high pressure
- Saves power
ACCESSORIES :
- 3 way hand shower
- Sliding Shower Rail set
- Soap dish
- Flexible Hose
- Inlet Valve, Screws & wall plugs
SAFETY :
- Automatic pressure switch to prevent heating element burn out
- High temp cut off at 55 C to prevent scalding
- Built-in ELB with Surge Protector
WARNING :
- This appliance must be earthed properly and installed vertically at 1.6 M to
1.8 M height from ground level for proper operations.
- Water outlet acts as vent and must not be fitted to any tap or any concealed
fitting is not recommended
- Stop valve must be connected ONLY to inlet.
- In case of malfunction, switch off mains power at once..
Installation Manual / operation guidelines
Model : 1188EP (With DC Booster Pump)
: 3 Kw , 220 V-240 V, 50 Hz
: 3 PSI/0.2 Kgf/cm (6 ft below water tank)
: 55 PSI/3.87 Kgf/cm
: 15 mm (½ " BSP)
: Variable step less electronic control
: Variable step less electronic control
: 322 (H) x 220 (W) x 82 (T) mm
: 525 (H) x 265 (W) x 120 (T) mm – 3 ply
0
Most suited for coastal & warm climates
2
2
Model : 1188EP (With DC Booster Pump)
Instant Shower Geyser

Advertisement

loading

Summary of Contents for Balgo 1188EP

  • Page 1 Instant Shower Geyser Installation Manual / operation guidelines Model : 1188EP (With DC Booster Pump) Most suited for coastal & warm climates SPECIFICATION : Power : 3 Kw , 220 V-240 V, 50 Hz Min Water Pressure : 3 PSI/0.2 Kgf/cm (6 ft below water tank) Max Water Pressure : 55 PSI/3.87 Kgf/cm...
  • Page 2 Open top and bottom screws and pull top cover Mounting Holes Mounting Holes Knockdown Knockdown for concealed for concealed wiring wiring Mounting holes & knockdown for concealed wiring Mounting Holes Mounting Holes Mounting Holes Mounting Holes Model : 1188EP (With DC Booster Pump)
  • Page 3 TO REPLACE THE TOP COVER : - Ensure that temperature & pump control of the unit and top cover are adjusted to zero for knob alignment Place the top cover gently and screw Model : 1188EP (With DC Booster Pump)
  • Page 4 - You may clean heater with damp cloth and mild detergent but do not use thinner, petrol or any corrosive solutions. Model : 1188EP (With DC Booster Pump)