Summary of Contents for BACK SONAR SPBS
- Page 1 SPBS REVERSING OBSTACLE SENSOR ACHTERUIT RIJ SENSOR DETECTEUR D’OBSTACLES EN MARCHE ARRIERE MANUAL HANDLEIDING MANUEL D’UTILISATION BACK SONAR...
- Page 2 BACK SONAR REVERSING OBSTACLE SENSOR Wiring instruction and user manual 1. Features ♦ You can feel safe and have peace of mind and convenience as you reverse your vehicle. ♦ Easy parking in city area, especially for bumper to bumper situation (= reduce parking time) ♦...
- Page 3 Self-tapping screw 4 x 10mm Screw on bracket to bumper Double side tape sticker For sensors mounting (glued type) Wiring instruction & User manual This manual NOTE : for gluing type mounting, the items are not necessary. SPBS BACK SONAR...
- Page 4 SPBS BACK SONAR...
-
Page 5: Installation And Wiring
2. Glue the sensor on the boot cover at least 65cm above the road surface. If the mounting surface is slant or not flat, please cut the extra adhesive stickers and use them to flatten the mounting angle, keep the angle strictly vertical and horizontal. SPBS BACK SONAR... - Page 6 Installation diagram 1 : SPBS BACK SONAR...
- Page 7 3. Mount the sensor and bracket on the bumper at least 30cm, above ground, (the mounting bracket is bent upwards 45 degrees). If necessary, you can bend the bracket to adjust the detection angle. (Prevent picking up the road surface) SPBS BACK SONAR...
- Page 8 Installation diagram 2 : SPBS BACK SONAR...
- Page 9 Plug 2-pin male connector of shorter sensor cable (part item 2) into the other 2-pin female socket on ECU. NOTE : #2 and #3 connectors are interchangeable. 2. After the "Operation and Testing" procedures stated below, clean the entire wiring loom and attach it with wire band. SPBS BACK SONAR...
- Page 10 Fig. 3C) 5. If you encounter problems during operation and testing, please refer to the "Trouble shooting" table below. 6. When you have completed the above procedure, installation is complete and the system is ready for use. SPBS BACK SONAR...
- Page 11 (5) If the sensor element is covered by snow, ice, mud or other objects. (6) When the sensor receives interference from other ultrasonic transmission. (7) On irregular road surfaces, cobblestones, sloping streets and driving area with weeds. SPBS BACK SONAR...
-
Page 12: Troubleshooting
2. Both sensors are 2.If one sensor or both are damaged. damaged then replace with a new one. SPBS BACK SONAR... -
Page 13: General Specifications
* Additional function : Sensor Malfunction and system short indication * System configuration : Double Sensor type One control unit with two sensors Detecting range : 90 ± 5 cm, 90° 90° spread for vertical and horizontal SPBS BACK SONAR...