Strike Finder Pro II Quick Start Manual

Precision camera triggers

V. 2016.1 Strike Finder Pro II

Strike Finder

Before beginning, please make sure to set camera lens to Manual Focus!

Technical Information

• When you first turn on the Strike Finder™ Pro II, it will "boot-up", indicated by a few flashes of the

trigger LED.

• If the trigger LED doesn't flash when it "boots-up", it's time to replace the 9V battery or the battery

might be in backwards (I hate when I do that).

• To switch between the Lightning or Sound/Laser, turn the device oﬀ, switch the button to the either

"Lightning" or "Sound/Laser" and turn the device back on. is allows it to "boot-up" on the correct

sequence of code.

• Adjustment dial: e dial on the right side of the device serves as the lightning/laser sensitivity

adjustment. To set sensitivity, simply turn clockwise to maximize sensitivity and turn counter clockwise

to decrease it.

• To set the device using the Lightning setting, turn the device oﬀ, switch the button to Lightning and

turn it back on. Simply point a television remote at the front of the device (infrared sensor) and push

any button on the remote. is will cause the trigger LED to blink and release the camera shutter.

Note: e infrared emitted by a TV remote is the same as a lightning strike.

• Using the adjustment dial: Turn the sensitivity knob fully clockwise, it may blink intermittently (this

is because it is picking up ever so slight variations in light that we cannot see). Simply turn the dial

Strike Finder

Pro II

Strike Finder

ank you for purchasing the Strike Finder™ Pro II! e Pro II

was designed by photographers to use microcontroller technology

to capture images that would otherwise be humanly impossible.

precision camera triggers

™

Pro II

Table of Contents

Do you have a question about the Pro II and is the answer not in the manual?

Page 1 Before beginning, please make sure to set camera lens to Manual Focus! Technical Information • When you first turn on the Strike Finder™ Pro II, it will “boot-up”, indicated by a few flashes of the trigger LED. • If the trigger LED doesn’t flash when it “boots-up”, it’s time to replace the 9V battery or the battery might be in backwards (I hate when I do that).
Page 2 Sound/Laser setting, and turn it back on. e sound sensor is an attachment with the small “listening” hole. Plug it all the way into the Sound port (on the side of the Strike Finder™ Pro II). Gently tap the sound sensor or make some type of noise. e trigger should blink as often as the sensor detects sound.
Page 3 Pro II V. 2016.1 Strike Finder Pro II V. 2016.1 Strike Finder Elite Strike Finder precision camera triggers Continued from page 2 • When everything is set up, take a few photos to make sure you are happy with exposure of foreground and focus.