CellAlure Smart Temp Instructions Manual page 14

FCC Warning
Specific Absorption Rate (SAR) information SAR tests
are conducted using standard operating positions
accepted by the FCC with the phone transmitting at its
highest certified power level in all tested frequency
bands, although the SAR is determined at the highest
certified power level, the actual SAR level of the phone
while operating can be well below the maximum value,
in general, the closer you are to a wireless base station
antenna, the lower the power output.Before a new
model phone is a available for sale to the public, it must
be tested and certified to the FCC that it does not
exceed the exposure limit established by the FCC,
Tests for each phone are performed in positions and
locations (e.g. at the ear and worn on the body)as
required by the FCC.
For body worn operation, this mobile phone has been
tested and meets the FCC RF exposure guidelines
when used with an accessory designated for this
product or when used with an accessory that contains
no metal and that positions the handset a minimum of
1.0cm from the body.
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation. Any Changes or modifications not expressly
approved by the party responsible for compliance could
13