Related Manuals for pastoe LANDSCAPE
Summary of Contents for pastoe LANDSCAPE
- Page 1 LANDSCAPE design Joost van der Vecht 2012 LANDSCAPE - on a plinth LANDSCAPE - wall mounted pastoe sleepboot 4 3991cn houten the netherlands info@pastoe.com www.pastoe.com...
- Page 2 LANDSCAPE design Joost van der Vecht 2012 LANDSCAPE - on a plinth Components Bolt Ø6x20 Cap cover Cap cover hinge Bolt Ø6x35 Open compartment: Open compartment: Cap cover hinge connection part lamello...
- Page 3 Assembly instructions Place the plinth at the desired position and adjust until level Rotate the plinth so that the underside can be accessed and using the adjustable legs. place the body. Screw the body to the underside of the plinth using the supplied bolts (A;...
- Page 4 Assembly instructions 9 OPEN COMPARTMENT 10 OPEN COMPARTMENT screw the eccentric bolt into the side of the body and slide the Place the next body on the divider. Place the eccentric bolts (G) in open compartment construction plank into position. Secure this the side and slide it against the construction plank.
- Page 5 LANDSCAPE design Joost van der Vecht 2012 LANDSCAPE - wall mounted Components Open compartment: Bolt Ø6x20 Cap cover hinge Bolt Ø6x35 lamello Open compartment: Mounting plate Plug and screw Ø5x45 Cover mounting part connection part...
- Page 6 Assembly instructions NOTE: The cabinet must be assembled so it can be mounted on the wall. The cabinet is to be mounted on the wall as a whole. To do so, please follow the steps below. To mount cabinets starting at 2.85m on the wall, three people will be required. Secure the base from the bottom using the supplied bolts (B;...
- Page 7 Assembly instructions 14 40 40 30 Body width 285mm 40 30 Body width 570mm 40 30 Body width 855mm 40 30 Body width1140mm Open compartment width 285mm Open compartment width 570mm Holes to be drilled in the facing side: Drill the required holes in the wall according to the width of the body. Open compartments do not require (or have) hangers. Do take the width into account when measuring out where to drill the holes.
- Page 8 Assembly instructions When mounting a body with drawers, all drawers must be removed. Insert the plugs (H) into the drilled holes and secure the To do this, push in the snapper underneath the drawer and pull the Mounting plate (G) with the screws (I). drawer towards you.