Table of Contents
Advertisement
Quick Links
INSTANT BOILING WATER DISPENSER
Read this booklet thoroughly before using and
save it for future reference.
IMPORTANT SAFEGUARDS
Please make sure to follow below measures in operations of this water dispenser.
1.Read all instructions carefully before using.
2.Before use the appliance, please make sure the voltage indicated on the rating plate
corresponds to the wall outlet at your home, if not please do not operate it and connect your
local distributor for proper replacement.
3.Please check if the power cord, plug and the control panel is loose or damaged, or if the
housing is cracked or deformed due to the heavy hit, please do not use the appliance if in any
above cases, contact your local distributor immediately.
4.Do not operate the appliance without less water level to avoid damaging the heating elements.
5.Do not let the cord hang over the edge of table or counter, and not keep the appliance touch any
hot surface.
6.Do not place the appliance on or near any gas or electric burner or inside heated oven.
Instruction Manual
Model: WD400
1
Advertisement
Table of Contents
Related Manuals for Vees WD400
Summary of Contents for Vees WD400
- Page 1 INSTANT BOILING WATER DISPENSER Instruction Manual Model: WD400 Read this booklet thoroughly before using and save it for future reference. IMPORTANT SAFEGUARDS Please make sure to follow below measures in operations of this water dispenser. 1.Read all instructions carefully before using.
- Page 2 7.Do not put the appliance into a working disinfection cabinet. 8.Do not freeze the appliance in the refrigerator. 9.Do not lean the appliance or operate it upside down. 10.Do not use it outdoors. 11.This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety.
- Page 3 nearest authorized service agent or manufacturer for examination, repair or replacement, do not try to disassembly it by yourself. 24.This appliance is intended to be used in household and similar locations such as: – staff kitchen areas in shops, offices and other working environments; –...
- Page 4 3 Control panel details ON: Switch open(green light) OFF: Switch close 0: Normal temperature water 45C: 45 degree water 65C: 65 degree water 85C: 85 degree water 100C: boiling water 4 How To Use Before first use: If use the appliance for first time, please clean up the water tank before use. Always unplug from the plug socket before cleaning.
- Page 5 1. Fill in water Open the lid, fill the water tank with the desired amount of water, and then close the lid. Note: the water level must be less the Max level. You can select two methods as per the following Tips: Suggest to use purge water in the appliance 2、Obtain desired water Make sure the plug is connected to the proper wall outlet, and fill in the water with desired...
- Page 6 operation,if the unit is no power, stop working, not boiling the water, you can reset the thermostat by a reset key easily. --After cleaning the appliance, please open the drainage stopper in order to clean up waste water, Pls tighten the drainage stopper after opening it. Note: If found water leakage from the bottom, pls tighten the drainage stopper.
- Page 7 Replace the filter 、 If you select the appliance with the filter Open the tank cover, and take out the filter box with filter, go off with the old filter ,Use the new filter instead of it.(See photo) 5 Cleaning and Maintenances 1.Always switch off and unplug your water dispenser and allow it to cool completely before cleaning.
- Page 8 7 Technical specification Model no: WD400 Volume: 2.2L Rated: 220-240V,2200-2600W Frequency : 50/60Hz Environment friendly disposal Vees Kitchen Appliances Sdn. Bhd. (1399548-P) F-06-03, Setiawalk, Pusat Bandar Puchong, 47160 Puchong, Malaysia. Service Hotline: 03-86001648...
Need help?
Do you have a question about the WD400 and is the answer not in the manual?
Questions and answers
My Vees instant boiler can dispenser water but not hot. Water dispense without boiled
Your Vees WD400 instant boiler may be dispensing water that is not hot due to the following reasons:
1. No Power or Malfunction – If the unit has no power or is not boiling water, you may need to reset the thermostat using the reset key.
2. Low Water Level – Operating the appliance with insufficient water can damage the heating elements, affecting its ability to heat water properly.
3. Loose or Damaged Components – Check if the power cord, plug, or control panel is loose or damaged, as this can prevent proper heating.
4. Water Leakage – If there is water leakage from the bottom, ensure the drainage stopper is tightened, as leaks may affect performance.
5. Scale Buildup – If the spout has scale deposits, remove and clean it to restore proper operation.
If the problem persists, contact your local distributor for assistance.
This answer is automatically generated