Advertisement
Table of Contents
LARGE CRYSTAL PHOTO CUBE WITH BOX
CRCUBE5
Recommended Equipment
•
Standard Flat Heat Press
•
Teflon Sheet(s) or Blowout Paper
•
Green Sponge Heat Pad (XP8216 or XP8217) (recommended)
•
Heat Tape
•
Heat gloves or oven mitt
•
Paper towel or cloth with water or isopropyl alcohol
Recommended Settings (using Green Sponge heat pad)
•
Temperature: 390-400°F
•
Time: 270-300 seconds/ 4.5-5 min.
•
Pressure: Heavy
Recommended Settings (without Green Sponge heat pad)
•
Temperature: 355-360°F
•
Time: 180-210 seconds/ 3-3.5 min.
•
Pressure: Medium-Heavy
Advertisement
Table of Contents
Summary of Contents for Johnson Plastics Plus CRCUBE5
- Page 1 LARGE CRYSTAL PHOTO CUBE WITH BOX CRCUBE5 Recommended Equipment • Standard Flat Heat Press • Teflon Sheet(s) or Blowout Paper • Green Sponge Heat Pad (XP8216 or XP8217) (recommended) • Heat Tape • Heat gloves or oven mitt • Paper towel or cloth with water or isopropyl alcohol Recommended Settings (using Green Sponge heat pad) •...
- Page 2 General Sublimation Instructions (using Green Sponge heat pad) ***Use of the Green Sponge pad is preferred when sublimating the Crystal Cube.*** • Preheat heat press to 390-400°F. Set press time to 270-300 seconds/ 4.5-5 min. • Print image onto the transfer paper- TURN IMAGE MIRRORING OFF. •...
- Page 3 General Sublimation Instructions (without Green Sponge heat pad) • Preheat heat press to 355-360°F. Set press time to 180-210 sec./3-3.5 min. • Print image onto the transfer paper- TURN IMAGE MIRRORING OFF. • Trim the edges of the image if necessary and place transfer sheet face down on the back side (white coated side) of the Crystal Cube.
Need help?
Do you have a question about the CRCUBE5 and is the answer not in the manual?
Questions and answers