Table of Contents
Advertisement
Quick Links
Electric Guitar Pickup Box
BEFORE YOU BEGIN
SAFETY IS YOUR RESPONSIBILITY.
Make sure that all the components are included.
Always work in a well lit and ventilated area.
Wash hands after handling solder and components.
Use only proper tools.
Returns only accepted for unopened kits.
Send us an email at circuitmaster@gmail.com with any problems or questions.
Tools Needed for Basic Kit Assembly
25 watt or less soldering iron with a fine tip.
60-40 Flux-Core from Radio Shack or equivalent DO NOT USE ACID CORE or SELF CLEANING solder.
Wire Cutter for cutting long legs of components close to circuit board.
Wire Stripper for exposing the metal core of the insulated wire.
Third Hand or other assembly with a clip to hold the circuit board while soldering.
Copyright GetLoFi, LLC 2012
Created:
5/11/2013
Page 1 of 3
Advertisement
Table of Contents
Related Manuals for GetLoFi Electric Guitar Pickup Box
Summary of Contents for GetLoFi Electric Guitar Pickup Box
- Page 1 Electric Guitar Pickup Box BEFORE YOU BEGIN SAFETY IS YOUR RESPONSIBILITY. Make sure that all the components are included. Always work in a well lit and ventilated area. Wash hands after handling solder and components. Use only proper tools. Returns only accepted for unopened kits.
- Page 2 Make hoops from legs. Step: Single Coil Electric Pickup Carefully install the pickup using included springs and screws. Guide the pickup through. Its tight fit. Cut, strip, and tin the end-wires. Copyright GetLoFi, LLC 2012 Created: 5/11/2013 Page 2 of 3...
- Page 3 Solder a short wire from middle lug of potentiometer to same last pin of Jack where pickup HOT wire connected. Step: KNOB - BLACK Slide on the knob. Your finished project should look like this. Copyright GetLoFi, LLC 2012 Created: 5/11/2013 Page 3 of 3...
Need help?
Do you have a question about the Electric Guitar Pickup Box and is the answer not in the manual?
Questions and answers