Page 2
CAUTION: The Hazelbaker™ FingerFeeder was developed to assist you and your baby with breastfeeding, and to help get the baby on the breast. Read this manual carefully, it contains information you need to know to successfully use the Hazelbaker™ FingerFeeder. After the second or third day of delivery, you should look for indications that feeding is off to a good start.
Page 3
Cleaning Instructions After each use: Remove Cap, fill Bulb full of warm soapy water, replace Cap and force water through Tubing by gently squeezing the Bulb. Remove Cap, refill with clean water, replace Cap and again, gently squeeze the Bulb to force water through the Tubing. Completely disassemble the FingerFeeder and clean all parts (except Tape) with warm soapy water.
Page 4
Assembly Instructions Wash your hands thoroughly in warm soapy water. Healthcare professionals should wear a glove or finger cot while feeding a baby with this device. (It may not be necessary for baby’s parents to wear a glove or cot). Insert the Tubing Clamp into the recess on the Tubing end of the Bulb.
Page 5
Assembly Instructions Cont. The temperature of the supplement should be between room and body temperature before pouring the Bulb. This will allow the supplement to flow more freely through the Tubing. To warm cold breast milk, place in container in a bath of lukewarm water. Never microwave or boil breast milk. Insert the Disc/Membrane assembly into the large Slot opening of the Bulb, with the Membrane side inside the...
Page 6
Instructions for Use Position yourself and baby in a proper finger feeding position, such as shown in the drawing. Placing a pillow under baby will make feeding more comfortable for both of you, by raising baby to chest height. Keep your shoulders and elbows down and relaxed to reduce muscle strain.
Need help?
Do you have a question about the Hazelbaker FingerFeeder and is the answer not in the manual?
Questions and answers