crystal coolers K2 Quick Start Manual

ENSURE THE COOLER STANDS UPRIGHT FOR 24 HOURS BEFORE PLUGGING IT IN.

OPERATION

1. Stand cooler upright on flat, smooth floor. Align
sides plate with base, and slide into base to
locked position. The side plates are inserted so
that the inner faces mount flush in the rear of the
cooler. There will be an open triangular area in
the front.
3. Install a bottle of water on the top of the water
cooler. Note: To prevent water leaks, a NON-
SPILL Bottle Cap MUST be installed on the
bottle. Ensure that the hot water switch near the
top of the rear panel is turned off. Light will be
green when the hot water switch is in the off
position.
The light shows as
System is turned on.
K2 Water Cooler
Quick Start Guide
RED when the power to Hot
2. Place the water cooler indoors, on a flat level
surface in a cool shaded the location near a
grounded wall outlet. Position water dispenser
so that the back of the unit is a minimum of 4
inches away from the wall to ensure proper
ventilation.
4 inches
4. Plug power supply cord into receptacle. Please
ensure that cooler is set up so as access to the
power outlet and plug is unobstructed.
Note: To provide additional protection from
the risk of shock, this unit M U S T be
connected to a ground fault circuit interrupter
(GFCI) outlet at all times. Use of an extension
cord will void any warranties.