6.9 Add new remote control ..................11 6.10 Delete a single channel memory ................12 6.11 Delete all the memories ..................12 7. How to code the ODSIF switch ................13 7.1 How to use the ODSIF switch ................13 8. Trouble shooting ...................... 13 9.
Congratulations with your new roller blind system with RF remote control, and which can also be operated with ODSIF wireless wall switch. Read this manual carefully prior to installing and using the roller blind sytem to get the most out of your system.
OVERVIEW OF PARTS 2.1: Overview of parts Tubular motor Tube Brackets for tube and motor Adapter wheel Bottom list Remote control Screws and rawl plugs On receipt, check that the above parts are supplied. If any items should be missing, please contact you supplier prior to installing the product.
SYSTEM INSTALLATION 3. System installation Make sure there is enough space for the assembly of the product. The tools required for the installation of the product are electrical drills with 6-8 mm diameter drill bits (for concrete wall or ceiling), fi bre-measuring tape, cross head screw driver, hand saw and a pair of scissors.
SYSTEM INSTALLATION Samling af systemet Bracket Bracket Inner installation - the tube must be 3 cm shorter than the window width. Outer installation covering the window. 3.3 Adding the roller blind fabric Insert the suitable blind into the groove of the aluminium tube until it is fl at in posi- tion.
SYSTEM INSTALLATION 3.4 Adding the bottom list Place the bottom list at the end of the blind (see below fi gure) 3.5 Inserting the tubular motor and adapter wheel Insert the tubular motor and the adapter wheel into the aluminium tube at each end.
WARNINGS 4. Warnings when handling the motor Keep away from water. No knocking on the motor. No drilling of hole on motor tube. Downward cable - Keep away from corrodents. Do not immerse in water. avoid water infl ow. MOUNTING THE SYSTEM 5.
REMOTE CONTROL Features • Multiple limit preset, beside end limits, 4 extra middle limits settings • Keeps the limits stored, when the power is off • Self-checking and correcting of brake offset • Stop on block for security • Famous quality components to ensure reliable perfor- mance.
REMOTE CONTROL 6.3 Limit position setting A maximum of six different positions can be set, the furthest two positions called the UP and DOWN limit positions and the others called the middle limit position. When the fi rst limit position is the UP limit position (see below illustration), all other limit positions can only be set below this position;...
REMOTE CONTROL 6.5 Other limit position setting (if there’s no action within 30 s, the motor will exit from limit posi- tion preparation automatically) Move the motor Press the rear Motor jogs once, Press the rear PROG Motor jogs once to the desired PROG for 1 s.
REMOTE CONTROL 6.10 Delete a single channel memory Press “Stop” on the The motor jogs Press the rear Motor jogs once, and the programmed remote once. PROG for 1 s. single channel has now control for 5 s. been deleted. 6.11 Delete all the memories Method 1 Press “Stop”...
HOW TO CODE WALL SWITCH 7. How to code ODSIF wireless switch Press the program The motor jogs The motor jogs Press the up button on the tube once. once, and now the button on the for 1 s. switch has been...
Under no circumstances, ODSIF is responsible for operational loss, loss of profi t or other economic consequential loss. Our liability for damages cannot exceed the in-...