Imac Type Series Installation And Operation Instructions

Domestic meter pulser

Advertisement

IMAC PULSER TYPE III
Installation and Operations Instructions
For Use on Itron Metris 250, I-250 and 400A Diaphragm Gas Meters

PURPOSE:

To add a pulse signal to a gas meter with a ratio of
1 Pulse per 1 Cubic Foot

KIT INCLUDES:

(QTY: 1) Pulser Assembly (featuring a
Form 'A' Reed Switch)
(QTY: 1) Drive Hub Assembly
(QTY: 2) Security Seals
(QTY: 1) Identification
Label
Fillister
Head
Screws
/
1
"
#10-24 x
2
(from meter)
Panhead Screws
#10-24 x
(from meter)
Index
(from meter)
Index Cover
(from meter)
Drive Hub
Assembly
(included)
/
3
"
8
Pulser
Assembly
(included)
www.lincenergysystems.com
P: 215-946-2200
www.imacsystems.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Type Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Imac Type Series

  • Page 1 IMAC PULSER TYPE III Installation and Operations Instructions For Use on Itron Metris 250, I-250 and 400A Diaphragm Gas Meters PURPOSE: To add a pulse signal to a gas meter with a ratio of 1 Pulse per 1 Cubic Foot...
  • Page 2 Installing the IMAC PULSER TYPE III: index cover Detach the meter’s by unscrewing (3) fillister head screws. Once detached, set the index cover and the screws aside. The index cover and the screws will be used in later steps. a) If red security caps are present, tap them with a screwdriver to break through the security cap, and then remove the security caps with needle nose pliers.

This manual is also suitable for:

Type iType i-aType iiType iiiType ivType iv-a

Table of Contents