Advertisement
Dura-Whelp Box Assembly Instructions
Important
Save reusable shipping carton
for storing your Dura-Whelp
body
door
tray
1
. Square up the body section of your Dura-Whelp and
place on top of tray. On inside of tray flaps, remove
protective film from velcro tabs. Fold up tray flaps and
affix to the body section of your Dura-Whelp.
screw
rail with
tab
3
. Insert [2] rails with tabs on ends. Hold down firmly and screw
down through hole as shown. DO NOT OVER-TIGHTEN. Use
provided screws. [See detail for information]. Remove
protective film from velcro tabs on rails and affix to the Dura-
Whelp body.
velcro tabs
rail with tab
To dismantle the Dura-Whelp, clean then reverse steps 1, 2 & 3,and repack.
208-747-3605 Fax 208-747-3604
2
. Insert [2] rails (without tabs) into open slots on
the front and rear body section of the Dura-Whelp.
The door on the front of your Dura-Whelp slides
up & down.
4
. Your completed Dura-Whelp.
BreederBase
PO Box 8, Clifton, ID 83228
www.BreederBase.com
open slot
Important Notes:
Advertisement
