Advertisement
Instruction Sheet
ERGO Computer Transport Stand #350714
Hardware Kit
Dual Lock Set #2999452
1/4-20 Nut (4x) #0299310
Security Wrench #0299495
Unpack the cartons and check carefully
to determine that all of the components
have been supplied. Note that a 7/16"
wrench and a phillips head screwdriver
are required for assembly.
Use the screws provided with your monitor
to attach it to the monitor plate. The
dual lock provided in the Hardware kit
can be used to fasten the keyboard
to the keyboard tray.
800 Glen Avenue • Moorestown, N.J. 08057
800.257.2326 • FAX: 856.359.2249
www.omnimedbeam.com
0311.AS.OMNI
Base
Place the base
on the floor and
assemble the
column asssembly
Top
Column
Assembly
Assembly
Place the Top Assembly on top of
the Column Assembly and fasten in
place with the provided nuts.
Advertisement
Table of Contents
Summary of Contents for OmniMed 350714
- Page 1 Instruction Sheet ERGO Computer Transport Stand #350714 Hardware Kit Dual Lock Set #2999452 1/4-20 Nut (4x) #0299310 Security Wrench #0299495 Column Assembly Base Assembly Unpack the cartons and check carefully to determine that all of the components have been supplied. Note that a 7/16”...
- Page 2 Instruction Sheet CPU Holder - ERGO Computer Transport Stand Use the provided security screw wrench to loosen the Top Cover ofthe CPU Holder Remove the CPU Slide screw and insert the CPU slides into the base as shown with the smaller on top. Reinsert the screw loosely.
Need help?
Do you have a question about the 350714 and is the answer not in the manual?
Questions and answers