Table Of Comtents Safety Instructions Package Includes Specifications Getting To Know Your Air Purifier Getting Started Using Your Air Purifier Pairing Your Air Purifier With Govee Home App About The Filters Care And Maintenance Resetting The Filter Change Indicator Troubleshooting...
READ AND SAVE THESE INSTRUCTIONS Safety Instructions 1.General Safety Only use Air Purifier as described in this manual. ● Do not use without removing the plastic wrap from the filter. If not removed, the air purifier ● will not filter air, and may overheat, causing a fire hazard. Do not use the air purifier outdoors.
Page 4
LIRE ET CONSERVER CES INSTRUCTIONS La consignes de sécurité 1.La sécurité générale Utilisez le purificateur d'air intelligent seulement comme décrit dans ce manuel. ● Ne pas utiliser sans retirer le film plastique du filtre. S'il n'est pas retiré, le purificateur d'air ●...
sens. S'il ne rentre toujours pas, ne contournez pas cette fonction de sécurité et essayez de forcer la fiche dans la prise. Au lieu de cela, ne l'utilisez pas avec la prise. Ce purificateur d'air utilise des prises standard US 120V, 60Hz. Si vous utilisez en dehors des ●...
Getting To Know Your Air Purifier a. Fan Speed Indicator j. Filter Change Indicator & Button b. Fan Speed Button k. Air Outlet c. On/Off Button l. Housing d. Sleep Mode Button m. Air Inlet e. Timer Button n. Power Cord f.
Getting Started 1. Flip the air purifier over. Twist the 2. Remove the filter from its plastic packaging screw nut counter clockwise and and place the filter back into the air purifier. remove bottom filter cover. 3. Reattach the filter cover and twist 4.
Using Your Air Purifier Using Govee Home App allows access to additional functions and features, along with the ability to control the air purifier remotely. 1. Functions & Controls Power On & Off ❶ Plug in the power cord, and all lights will flash once. The air purifier will then enter stand-by status automatically.
Page 9
Night Light ❶ Tap once to turn on the night light. ❷ Tap again to turn off the night light. Note: You can turn the night light on and off using the Night Light button, even when the air ● purifier is turned off...
2. LED Indicators Working Status Indicator Status Power On Power Indicator lights up white Fan Speeds I, II, and III Indicators separately light up blue Timers 2h, 4h, and 8h Indicators separately light up blue Filter Change Needed Filter Change Indicator lights up red Locked Lock Indicator lights up white Sleep Mode On...
About The Filters The air purifier uses a 3-stage filtration system to purify air. Pre-Filter Captures large particles such as dust, lint, fibers, hair, and pet fur. ● Maximizes the filter’s life by protecting it from large debris. ● H13 True HEPA Filter Captures at least 99.97% of airborne particles 0.3 microns (µm) in size.
For smaller rooms, the air change per hour will increase. This air purifier has an air change ● per hour of 5, which means it can change air 5 times per hour at the max speed in a single, closed room up to 183 ft² / 17m². The air purifier is effective for larger rooms, but air purification will take longer, with fewer air changes per hour.
Replacing the Filter The filter should be replaced every 6–8 months. You may need to replace your filter sooner or later depending on how often you use your air purifier. Replacing Steps 1. Unplug the air purifier. Flip the air purifier over and remove the bottom filter cover. 2.
Storage If not using the air purifier for an extended period of time, wrap both the air purifier and the filter in plastic packaging and store in a dry place to avoid moisture damage. Troubleshooting The troubleshooting section below is for solving frequently asked questions for the purifier unit.
Page 15
Poor air purifica- Tap Fan Speed Button to increase the fan speed. tion quality. Make sure no objects are blocking the sides or top of the air purifier (the inlet or outlet). Make sure the filter is removed from its packaging and is properly installed.
Page 16
FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Page 17
FCC Radio Frequency Exposure Statement The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be collocated or operating in conjunction with any other antenna or transmitter, End-Users must be provided with transmitter operation conditions for satisfying RF exposure compliance.
Need help?
Do you have a question about the AP-M1010L and is the answer not in the manual?
Questions and answers