Ziffun 136B Instruction Sheet

POOLSIDE BASKETBALL GAMES
GENERAL INFORMATION
It may be helpful to have the assistance of another person while assembling this game.
Read all directions thoroughly before beginning to assemble this game.
TOOLS:
The following tools will be needed for the assembly of this game:
Phillips or slot head screw driver
Small crescent wrench
PARTS Fig 1:
Please lay out all components on the floor and compare them to the following list to make sure that game is complete.
Part No. Quantity Description
1 One
2 One
3 One
4 One
5 One
6 One
7 One
8 Five
9 Four
10 Four
11 Four
ASSEMBLY (see Figure 1) Read directions thoroughly before assembling.
1. Insert the narrow end of the Support Arm Post (6) through bottom of Porta-Base (2). The flanged portion of the post is the
bottom. See Figure 1.
3. Slide Support Arm Brace (7) down over the Support Arm Post (6) so that it is perpendicular to the Support Arm Post.
2. Set Backboard Support Arms (5) on top of Support Arm Post (6) facing toward tabs on the front of the Base. Align the holes
on Support Arms connection and Support Arm Post and insert one Nylon Pin (8) to secure.
3. Set Backboard (1) on top of the front tabs on the Base (2). Align holes and insert nylon pins through the bottom of the base.
Swing the square mounting plate on the Support Arm Brace (7) so it aligns with the holes in the back of the Backboard (1). Align
the Support Arm Assembly (7) arms on the inside back of the Backboard (1) with the holes on the sides of the Backboard (1) and
insert Nylon Pins through (See Fig.1). (You may have to "bend" the arms a little for the holes to line up)
4. Attach the Hoop (3) to the Backboard (1) and the Support Arm Brace (7). See Fig.1. First, align hoop plate, backboard and
support arm brace plate. Insert one hex bolt (9) through a hole in the rim plate, through the backboard and the Support Arm
Brace plate. Secure from the back with a 5/16" fender washer (11) followed by a 5/16" hex nut (10). Secure loosely until all four
bolts are in place, then tighten each equally. Do not over-tighten as this may damage both the backboard and the support arm
brace.
5. Attach the net to the hoop.
6. Fill Base with water or sand and have fun!!!
water activities division
Backboard 35"x 35"
Porta-Base w/ plug
Hoop
Net
Backboard support arms assembly w/caps
Support arm post
Support arm brace
Nylon pins
5/16 x 1¼" hex bolts
5/16 nylon insert nuts
5/16 fender washers
(Formerly Ziffco)
The Oreq Corporation
MODEL # 136B